7. NOISE ABATEMENT - The procedures described below are mandatory and designed to minimize aircraft noise disturbance to homes near the Fresno airports. Your compliance with our noise abatement procedures is extremely important in maintaining goodwill between the airports, military and the surrounding communities. The Fresno Yosemite International procedures reflect policies established by the FAR Part 150 Airport Noise Compatibility Program (City of Fresno Ordinance No. 92-77). Please take a few moments to familiarize yourself with the procedures.
a. ALL AIRCRAFT
(1)
Traffic Pattern Altitudes: 803’ MSL - Helicopters 1303’ MSL - Single-Engine Airplanes (reciprocating engine) 1803’ MSL - Multiengine Airplanes (reciprocating engine & turboprop) 2303’ MSL - Turbojet Airplanes

(2)
Intersection takeoffs from Runway 29L are not permitted, except during single-runway capability operations (Runway 11L-29R closed/unusable). Intersection takeoffs from Runway 29R are only permitted from Taxiway "B2", except during single-runway capability operations (Runway 11R-29L closed/unusable).

(3)
Test- or check-flights, practice landings and low approaches, and stop- or touch-and-go operations are permitted only between 0700 and 2200 local time Monday through Saturday, and between 1000 and 1800 local time on Sundays. Note: Contact ANG Operations for prior coordination of any flight requirements outside these hours.

(4)
Engine maintenance run-ups are permitted between 0500 and 2200 local time on the Taxiway "B2" run-up pad (between Runway 29L and Taxiway "B") only, except for other time periods and/or locations authorized by ANG Operations in advance.

b.
SMALL SINGLE-ENGINE & MULTI-ENGINE AIRPLANES (maximum certificated takeoff weight less than 12,500 lbs.): After takeoff, climb on runway heading until passing 850' MSL (single-engine) or 1000' MSL (multiengine). For safety and noise abatement, initial climbout at best rate-of-climb (Vy) is recommended.

c.
ALL AIRCRAFT (maximum certificated takeoff weight over 12,500 lbs.):

(1)
VFR ENROUTE PROCEDURES/ARRIVALS Ensure contact with ATC prior to entering Class “C” airspace. Expect left-hand traffic pattern for Runway 11L -- right-hand pattern for Runway 29R.

(2)
When conducting VFR test-,check-, or training-flights and making approaches to Runway 11L, maintain at or above 2000' MSL until established on a 5 nautical mile (localizer DME) final.

(3)
A normal approach path (approximate 3° angle) will be flown on final.

(4)
No practice missed-approaches or go-arounds to Runway 11L.

(5)
Opposite direction approaches to Runway 11L are not authorized when Runway 29R is in use.

(6)
Runway 11L Preferential Usage: Should Runway 29R be in use, large turbojet aircraft will receive an ATC clearance for an opposite-direction takeoff on Runway 11L, on a flight safety-and weather-permitting basis, between the local hours of 2400 and 0500.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：DFIP AREA PLANNING NORTH AND SOUTH 2(29)