曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

ENG START selector...............................................................................................................NORM
Applicable to: ALL
L/G
L/G lever.........................................................................................................Check DOWN position
Applicable to: ALL
WIPERS
WIPERS..................................................................................................................................... OFF
Applicable to: ALL
ELEC
�� If the aircraft has not been electrically supplied for 6 h or more, perform the following
check.
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw.................................................. CHECK OFF
BAT 1 and 2 and APU BAT VOLTAGE..................................................CHECK ABOVE 25.5 V
Battery voltage above 25.5 V ensures a charge above 50 %. After the check, the selector
should remain on APU position to avoid discharge of BAT 1 or 2.
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES
- PRELIMINARY COCKPIT PREPARATION
A330/A340 FLEET PRO-NOR-SOP-04 P 2/10
FCOM 19 AUG 10
�� If battery voltage is below 25.5 V:
a charging cycle of about 20 min is required.
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw.......................................................AUTO
EXT PWR......................................................................................................................... ON
Check on ELEC DC SD page, battery contactors closed and batteries charging.
�� after 20 min:
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw......................................................... OFF
BAT 1 and 2 and APU BAT VOLTAGE........................................... CHECK ABOVE 25.5 V
After the check, the selector should remain on APU position.
�� If battery voltage is above 25.5 V:
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw.......................................................AUTO
Note: The ground horn will be triggered, associated with the ventilation EXTRACT
FAULT illumination and ECAM warning after 5 min when the aircraft is supplied
with batteries only.
�� If the aircraft has been electrically supplied during the last 6 h
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw.............................................................AUTO
Note: In case of APU start on battery only, perform the following check:
BAT 1 pb-sw, BAT 2 pb-sw and APU BAT pb-sw.............................................. AUTO
BAT 1 and 2 and APU BAT.....................................................CHECK ABOVE 23.5 V
If one battery voltage is lower than 23.5 V, there is a risk of aborted APU start.
A charging cycle of the battery is required.
EXT PWR (if AVAIL is on)............................................................................................................ON
AVAIL goes out.
Note: 1. When only one electrical power is available it is recommended to connect EXT PWR A
since:
EXT PWR B does not permit GND/FLT buses ‐ to be supplied directly without
energizing the total aircraft network.
‐ EXT PWR B cannot be used simultaneously with APU GEN.
2. If AVAIL does not come on (EXT PWR connected) or ON/AVAIL go out during
EXT PWR operation, the GPCU protection has tripped. Reset using the EXT PWR.
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES
- PRELIMINARY COCKPIT PREPARATION
A330/A340 FLEET PRO-NOR-SOP-04 P 3/10
FCOM 19 AUG 10
Applicable to: ALL
HYD
WARNING Do not pressurize hydraulic systems without clearance from ground crew.
APU FIRE TEST/START
Applicable to: ALL
APU FIRE
APU FIRE pb-sw...................................................................................................IN and GUARDED
AGENT light ............................................................................................................................... OUT
If the APU is already running ensure that the following check has already been completed.
If not, perform it.
APU FIRE TEST pb .............................................................................................................. PRESS
Check:
‐ APU FIRE warning on ECAM + CRC + MASTER WARN light
‐ APU FIRE pb-sw lighted red
‐ APU SQUIB light and APU DISCH light on.
Applicable to:
APU START
APU MASTER SW pb-sw ............................................................................................................ON
APU ON light comes on.
APU SD page appears on ECAM.
Note: If batteries only are supplying, press the APU pb on the ECAM control panel during the
start sequence (to permit the ECAM upper display to display the APU SD page).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A330/A340機組操作手冊 FLIGHT CREW OPERATING MANUAL FCOM 9(98)