曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

panel) come on.
ANN LT sw................................................................................................................................ BRT
Check that all lights go off.
CKPIT DOOR................................................................................CHECK CORRECT OPERATION
Set the toggle switch to the UNLOCK position. Check that the door opens, and that the OPEN light
comes on.
Then, with the door fully opened, release the toggle switch (check that it returns to the NORM
position). Close the door. Check that it is locked, and that the OPEN indicator goes off.
CKPIT DOOR MECHANICAL OVERRIDE............................................................................ CHECK
Check that the door opens normally, and that it closes when the mechanical override is used.
Applicable to: ALL
SWITCHING PANEL
* SWITCHING panel............................................................................................................. CHECK
Check all selectors at NORM
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - COCKPIT PREPARATION
A330/A340 FLEET PRO-NOR-SOP-06 P 9/22
FCOM 19 AUG 10
Applicable to: ALL
*ECAM CONTROL PANEL
STS pb..................................................................................................................................PRESS
Check that INOP SYS display is compatible with MEL.
If a message is displayed in MAINTENANCE STATUS, see PARKING procedure Refer to
PRO-NOR-SOP-25-A PARKING - PARKING BRAKE.
Applicable to: ALL
*PRESS PUSHBUTTON
* PRESS pb...........................................................................................................................PRESS
Check that the PRESS SD page displays LDG ELEV AUTO to confirm correct position of the LDG
ELEV selector.
Applicable to: ALL
ENGINES
* THRUST lever...........................................................................................................CHECK IDLE
Check reverse levers stowed.
ENG MASTER sw..........................................................................................................CHECK OFF
ENG START selector.................................................................................................CHECK NORM
Applicable to: ALL
ATC
ATC...............................................................................................................SET FOR OPERATION
Perform the appropriate ATC selection to allow the ATC transponder to operate in mode S (Refer
to DSC-34-50-30 REMOTE ATC BOX). TCAS is on standby. To prevent possible interference to
radar surveillance systems, TCAS should not be selected before the holding point/lining up.
ATC SYS 1........................................................................................................................... SELECT
For RVSM operations (Refer to PRO-SPO-50 REQUIRED EQUIPMENT/FUNCTIONS FOR
RVSM), select SYS 1 if AP 1 is used, and SYS 2 if AP 2 is used.
Only system 1 is available in the Emergency Electrical Configuration.
RMP
Applicable to: ALL
RMP ................................................................................................................................................ON
Green NAV light.................................................................................................................CHECK OFF
SEL light...........................................................................................................................CHECK OFF
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - COCKPIT PREPARATION
A330/A340 FLEET PRO-NOR-SOP-06 P 10/22
FCOM 19 AUG 10
COM FREQUENCIES...................................................................................................................TUNE
Use VHF 1 for ATC (only VHF 1 is available in emergency electrical configuration), VHF 2 for ATIS
and company frequencies. VHF 3 is normally devoted to ACARS.
AIRFIELD DATA
Applicable to: ALL
Obtain data needed for initializing the system and preparing the cockpit. This should include:
RUNWAY IN USE, ALTIMETER SETTING, and WEATHER DATA.
ATC CLEARANCE
Applicable to: ALL
Obtain ATC clearance, or use the probable clearance.
ACARS ��
Applicable to:
Initialize ACARS at that point, or after FMGS INITIALIZATION, as per company policy.
ACARS
Applicable to: ,
Initialize ACARS at that point, or after FMGS INITIALIZATION, as per company policy.
FMGS INITIALIZATION
Applicable to: ALL
GENERAL
At electrical power-up, the FMGSs and FCU run through various internal tests. Allow enough time
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A330/A340機組操作手冊 FLIGHT CREW OPERATING MANUAL FCOM 9(114)