R 1EFF : 051-052, 1 52-32-00Page 403 1 1 May 01/05 1 1 1CES 1
R TASK 52-32-00-440-002
R Reactivation of the Locking Handle
R 1. Reason for the Job__________________
R Refer to the CDL TASK: 52-8
R Cargo door opening system
R Handle of cargo door
R 2. Job Set-up Information______________________
R A. Referenced Information
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R 52-32-21-000-001 Removal of the Locking Handle Mechanism
R 52-32-21-400-001 Installation of the Locking Handle Mechanism
R ASRM 52-32-00-201 (for corrective action)
R 3. Job Set-up__________
R Subtask 52-32-00-860-058
R A. Aircraft Maintenance Configuration
R (1) Make sure that the access cover 826AR is removed from the AFT cargo
R compartment door (referred to as cargo door).
R (2) Make sure that the parts retained from the removed component are
R clean and in the correct condition.
R 4. Procedure_________
R Subtask 52-32-00-020-052
R A. Removal of the Locking Handle
R (1) Remove the high-speed tape from cargo door skin around the handle
R recess.
R (2) Remove the damaged locking handle (Ref. TASK 52-32-21-000-001).
R 1EFF : 051-052, 1 52-32-00Page 404 1 1 May 01/05 1 1 1CES 1
R Subtask 52-32-00-420-052
R B. Install the new or repaired locking handle (Ref. TASK 52-32-21-400-001).
R NOTE : The repair of the locking handle is described in the SRM (Ref.
____ R ASRM 52-32-00-201).
R 1EFF : 051-052, 1 52-32-00Page 405 1 1 May 01/05 1 1 1CES 1R **ON A/C ALL
TASK 52-32-00-040-003
Deactivation of the Locking Hooks and Spools
1. Reason for the Job
__________________
Refer to the MMEL TASK: 52-30-02
Doors - Cargo
Cargo door locking hooks and spools
(FAA Only)
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 52-30-00-860-002 Close the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 52-32-00-991-007 Fig. 401
1EFF : ALL 1 52-32-00Page 406 1 1 May 01/05 1 1 1CES 1
3. Job Set-up
__________
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
Subtask 52-32-00-010-055
A. Get Access
(1)
Open the AFT cargo compartment door (referred to as cargo door) and safety it with the actuator safety locks (Ref. TASK 52-30-00-860-001).
(2)
Put the access platform in position below the opened cargo door.
(3) Remove the access panel 826AR from the cargo door. R **ON A/C 151-199, 401-499,
Subtask 52-32-00-010-055-A
A. Get Access
(1)
Open the AFT cargo compartment door (referred to as cargo door) and safety it with the actuator safety locks (Ref. TASK 52-30-00-860-001).
(2)
Put the access platform in position below the opened cargo door.
(3) Remove the access panels 826AR, 826BR and 826CR from the cargo door. **ON A/C ALL
Subtask 52-32-00-860-059
B. Aircraft Maintenance Configuration
(1) Deactivate the interlock mechanism of the opened cargo door as follows:
NOTE : This procedure is only necessary, if one of the locking hooks
____
is damaged or inoperative.
(a) Press the roller lever of the interlock mechanism outboard to release the blockage of the locking shaft. 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門5(2)
