1EFF : ALL 1 52-32-11Page 402 1 1 Aug 01/05 1 1 1CES 1 Subtask 52-32-11-865-062

 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 Subtask 52-32-11-860-059
 C. Aircraft Maintenance Configuration
 (1)
 Put a crane with a minimum capacity 130.0 kg (286.6 lb) in position to the cargo door.

 (2)
 Attach the SLING - CARGO DOORS (98A52307529001) to the crane.

 (3)
 Prepare the cargo door as follows:

 (a)
 Remove the self-adhesive patches (1) from the plastic caps (6).

 (b)
 Remove the plastic caps (6) from the hoisting fittings (3) and install the hoisting lugs (2) with the eye-ends outboard.

 (c)
 Attach the fasteners (4) of the sling (5) to the eye-ends of the hoisting lugs (2).

 (4)
 Make sure that the Yellow hydraulic system is depressurized and put it in the maintenance configuration. (Ref. TASK 29-00-00-864-001).

 4. Procedure
_________ R **ON A/C 001-049, 053-099, 101-149, 201-299, 301-399,
 (Ref. Fig. 401/TASK 52-32-11-991-005) R **ON A/C 051-052,
R (Ref. Fig. 401A/TASK 52-32-11-991-005-B)
 1EFF : ALL 1 52-32-11Page 403 1 1 May 01/05 1 1 1CES 1

 Electrical Equipment and the Door Actuators
 Figure 401/TASK 52-32-11-991-005

R 1EFF : 001-049, 053-099, 101-149, 201-299, 1 52-32-11Page 404 1301-399, 1May 01/05 1 1 1CES 1R Electrical Equipment and the Door Actuators R Figure 401A/TASK 52-32-11-991-005-B

R 1EFF : 051-052, 1 52-32-11Page 405 1 1 May 01/05 1 1 1CES 1R **ON A/C 151-199, 401-499,

 (Ref. Fig. 401B/TASK 52-32-11-991-005-A)
 **ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,

 (Ref. Fig. 402/TASK 52-32-11-991-006) R **ON A/C 151-199, 401-499,
 (Ref. Fig. 402A/TASK 52-32-11-991-006-A)
 **ON A/C 001-049, 053-099, 101-149, 201-299, 301-399,

 Subtask 52-32-11-020-050
 A. Removal of the Cargo door
 (1)
 Disconnect the electrical connector (20) from the receptacle (19) and remove the wire harness 4613VB (21) from the ceiling lining of the actuator area (Ref. TASK 52-32-24-000-001).

 (2)
 Disconnect the door actuators from the cargo door as follows:

 (a)
 Remove the nut (9), the washer (11), the bolt (12) and the bonding jumper (10) from the actuator attachment fitting (13).

 (b)
 Remove the cotter pin (17), the nut (16) and the washer (15) from the bolt (14).

 (c)
 Hold the piston eye end (18) so that it cannot fall when you remove the bolt (14).

 (d)
 Remove the bolt (14) with the washer (15) and disconnect the piston eye end (18) from the actuator attachment fitting (13).

 (e)
 If neceesary, remove the bushes (22) and (23) from the actuator attachment fitting (13).

 (3)
 Remove the screws (31) and the end fittings (30) with the shims (29) from the piano hinge area.

 1EFF : ALL 1 52-32-11Page 406 1 1 Aug 01/05 1 1 1CES 1

 Electrical Equipment and the Door Actuators Figure 401B/TASK 52-32-11-991-005-A
R 1EFF : 151-199, 401-499, 1 52-32-11Page 407 1 1 Aug 01/05 1 1 1CES 1

 Connection of the Piano Hinge Halves
 Figure 402/TASK 52-32-11-991-006

R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-32-11Page 408 1301-399, 1May 01/05 1 1 1CES 1

 Connection of the Piano Hinge Halves
 Figure 402A/TASK 52-32-11-991-006-A

R 1EFF : 151-199, 401-499, 1 52-32-11Page 409 1 1 Aug 01/05 1 1 1CES 1

 (4) Apply masking material to the adjacent fuselage area to prevent damage during the removal of the hinge pins (24).
 (5) Make sure that the sling (5) is tight and that there is no load on the hinge pins (24).
 (6) Remove the SUPPORT STRUT - CARGO DOORS (98D52307524000) from the cargo door.
 (7) Remove the hinge pins (24) and the washers (25 thru 28) from the piano hinge area with EXTRACTOR - HINGE PINS, CARGO DOOR (98D52307523000).
 (8) Carefully remove the cargo door from the fuselage and put it in an applicable fixture. 
R  **ON A/C 051-052, 
R  Subtask 52-32-11-020-050-B 
R  A. Removal of the Cargo door 
R R R  (1) Disconnect the electrical connector (20) from the receptacle (19) and remove the wire harness 4613VB (21) from the ceiling lining of the actuator area (Ref. TASK 52-32-24-000-001). 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門5(19)