1EFF : ALL 1 32-44-21Page 404 1 1 Aug 01/05 1 1 1CES 1R **ON A/C ALL
4. Procedure
_________
(Ref. Fig. 401/TASK 32-44-21-991-001)
Subtask 32-44-21-420-050
A. Installation of the Brake Yellow Pressure Triple Indicator
(1)
Remove the blanking caps from the electrical connectors.
(2)
Connect the electrical connector (1) to the indicator (3).
(3)
Install the indicator (3) in its housing.
(4) Tighten the screws (2).
Subtask 32-44-21-865-053
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 61GG
Subtask 32-44-21-710-050
C. Operational test
(1)
Do the operational test of the Alternate braking system . (Ref. TASK 32-43-00-710-001)
(2)
Do the operational test of the parking brake system . (Ref. TASK 32-45-00-710-001)
5. Close-up
________
Subtask 32-44-21-942-050
A. Put the aircraft back to its initial configuration.
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 32-44-21Page 405 1 1 Aug 01/05 1 1 1CES 1
PARKING/ULTIMATE EMERGENCY BRAKING - DESCRIPTION AND OPERATION
______________________________________________________________
1. General_______
**ON A/C 001-049, 051-099, 101-105, 151-154, 201-207,
(Ref. Fig. 001) When you set the PARK BRK control switch to the ON position, this deactivates the other modes and supplies the brakes with Yellow high pressure. If Yellow high pressure is not available the brake Yellow pressure accumulator supplies power limited at 145 bar (2103.0466 psi) to the brakes. The accumulator has sufficient capacity to hold the brakes on for a minimum time of twelve hours. The TO CONFIG warning light (on the ECAM control panel) reminds the crew to release the parking brake when the engine is at full throttle.
**ON A/C 001-049, 101-149, 151-199, 201-299, 301-399,
Post SB 32-1201 For A/C 001-049,101-105,151-154,201-207,
(Ref. Fig. 001) When you set the PARK BRK control switch to the ON position, this deactivates the other modes and supplies the brakes with Yellow high pressure. If Yellow high pressure is not available the brake Yellow pressure accumulator supplies power limited at 145 bar (2103.0466 psi) to the brakes.
If the parking brake pressure decreases to less than 35 bar (507.6319 psi) when the PARK BRK is in ON position, the system reactivates the Normal Braking mode automatically.
The accumulator has sufficient capacity to hold the brakes on for a minimum time of twelve hours. The TO CONFIG warning light (on the ECAM control panel) reminds the crew to release the parking brake when the engine is at full throttle.
1EFF : 001-049, 051-099, 101-149, 151-199, 1 32-45-00Page 1 1201-299, 301-399, 1Config-1 Aug 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
2. Component Location
__________________
(Ref. Fig. 002, 003, 004, 005)
-------------------------------------------------------------------------------FIN | FUNCTIONAL DESIGNATION | PANEL|ZONE|ACCESS | ATA | | | | DOOR | REF.
-------------------------------------------------------------------------------72GG CTL VALVE-PARK BRK,ELEC. 148 744 32-45-51 73GG CTL SW-PARK BRK 110VU 211 831 32-45-52
2578GM DUAL SHUTTLE VALVE-BRK YELLOW PRESS 148 744 32-45-16 2579GM VALVE-PARK BRK OPERATED 148 744 32-45-14
3. Component Description
_____________________
A. PARK BRK Control A two-position control switch identified PARK BRK installed on the center pedestal controls the parking/ultimate emergency braking system. (Ref. Fig. 006)
B. Parking-Brake Electrical Control-Valve The parking-brake electrical control-valve is located in the hydraulics compartment. It receives signals from the ON position of the PARK BRK control switch through an electrical linear transmitter. (Ref. Fig. 007) The electrical control is duplicated (2 channels). (Ref. Fig. 008, 009) The figures below show the principle of operation of one linear transmitter channel. (Ref. Fig. 010) When you put the PARK BRK control switch in the ON (Park) position, this energizes the linear transmitter coil. The transmitter then reaches the stop in almost 2 seconds. The limit switch de-energizes the coil. The limit position is indicated in the cockpit through a switch connected in parallel. When you set the PARK BRK control switch to the OFF (Normal) position, this energizes the opposite contact. The transmitter then reaches the opposite stop in almost 2 seconds. Then, another limit switch de-energizes the coil. The linear transmitter operates a hydromechanical valve which connects the accumulator pressure from port A to service ports C and D. (Ref. Fig. 007) The valve limits the parking brake pressure at port C up to 145 bar (2103.0466 psi). The pressure at port C pushes back the control piston which causes the valve to close.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架7(148)
