(b)
 Remove the emergency-exit door-frame linings 241LW (242LW), 214CW (242CW) (Ref. TASK 25-23-47-000-002).

 (8)
 Remove the insulation blankets in the area that you are working (Ref. TASK 25-80-00-000-001).

 (9)
 Remove the proximity switches 5WN1 and 5WN2
 (Ref. TASK 52-73-11-000-003).

 (10) Remove the proximity switches 6WN1 and 6WN2
 (Ref. TASK 52-73-11-000-004).

R  **ON A/C 151-199, 401-499,
 Subtask 25-62-43-010-058-A
 B. Get Access
 (1)
 Open the AFT cargo-compartment door with the yellow electric pump (Ref. TASK 52-30-00-860-001).

 (2)
 Put the access platform in position at the AFT cargo-compartment door.

 (3)
 Put the warning notice on the AFT cargo-compartment door to tell persons not to close the door.

 (4)
 Do the special precautions before you work on the offwing escape-slide system(s) (Ref. TASK 25-62-00-481-001).

 (5)
 Remove the passenger seats in the area of the applicable emergency exit hatches (Ref. TASK 25-21-41-000-001).

 (6)
 Remove the applicable emergency exit hatches
 (Ref. TASK 52-21-11-000-001).

R  EFF : 001-049, 051-099, 101-149, 151-199, 25-62-43Page 429 201-299, 401-499, Aug 01/05
 CES

 (7) Remove the access panels: NOTE : Access panel numbers for the RH emergency escape-slide
____ release-mechanism assembly are given in the brackets.
 (a)
 Remove the cove light panel 241MW (242MW) (Ref. TASK 25-23-48-000-001).

 (b)
 Remove the emergency-exit door-frame lining 241FW (242FW) (Ref. TASK 25-23-47-000-002).

 (8)
 Remove the insulation blankets in the area that you are working (Ref. TASK 25-80-00-000-001).

 (9)
 Remove the proximity switches 6WN1 and 6WN2
 (Ref. TASK 52-73-11-000-004).

R  **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 4. Procedure
_________
 Subtask 25-62-43-020-056

 A. Disconnection of the Release Cable-Assembly
 (Ref. Fig. 403/TASK 25-62-43-991-009)

 (1)
 Remove and discard the lockwire (4) from the knurled sleeve-nut (5).

 (2)
 Loosen the knurled sleeve-nut (5) fully to get access to the two collets (7).

 (3)
 Remove and keep the two collets (7).

 (4)
 Disconnect the release cable-assembly from the flexible control-assembly:

 CAUTION : DO NOT PUSH THE END OF THE WIRE INTO THE WIRE-CONTROL
_______ ASSEMBLY. THIS CAN CAUSE A KINK IN THE WIRE.
 (a)
 Carefully remove the end of the release cable-assembly (2) from the related slot of the flexible control-cable (1).

 (b)
 Make sure that you do not push the end of the wire into the release cable-assembly (2).

R  EFF : 001-049, 051-099, 101-149, 151-199, 25-62-43Page 430 201-299, 401-499, Aug 01/05
 CES

 Release-Cable Connection Figure 403/TASK 25-62-43-991-009 
R  EFF : 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,  25-62-43 Page 431 Aug 01/05
 CES 

 (5)
 Remove the protective plug (6) from the pocket (3).

 (6)
 Put the two collets (7) in their position on the end of the release cable-assembly (2).

 (7)
 Move the knurled sleeve-nut (5) up and install the protective plug (6).

 Subtask 25-62-43-020-055
 B. Removal of the Emergency Escape-Slide Release-Mechanism
 **ON A/C 001-049, 051-099, 101-149, 201-299,

 (Ref. Fig. 404/TASK 25-62-43-991-003) R **ON A/C 151-199, 401-499,
 (Ref. Fig. 404A/TASK 25-62-43-991-003-A)
 **ON A/C 001-049, 051-099, 101-149, 201-299,

 (Ref. Fig. 405/TASK 25-62-43-991-004) R **ON A/C 151-199, 401-499,
 (Ref. Fig. 405A/TASK 25-62-43-991-004-A)
 **ON A/C 001-049, 051-099, 101-149, 201-299,

 (Ref. Fig. 406/TASK 25-62-43-991-005) R **ON A/C 151-199, 401-499,
 (Ref. Fig. 406A/TASK 25-62-43-991-005-A)
 **ON A/C 001-049, 051-099, 101-149, 201-299,

 (Ref. Fig. 407/TASK 25-62-43-991-006)
R  EFF : 001-049, 051-099, 101-149, 151-199, 25-62-43Page 432 201-299, 401-499, Aug 01/05
 CES

 Emergency Escape-Slide Release-Mechanism Assembly Figure 404/TASK 25-62-43-991-003 
R  EFF :  001-049, 051-099, 101-149, 201-299,  25-62-43 Page 433 May 01/05
 CES 

 Emergency Escape-Slide Release-Mechanism Assembly Figure 404A/TASK 25-62-43-991-003-A 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備4(93)