(7)
 Do a check of the inflation hose (17). If the hose is twisted, loosen the inflation hose attach-nut (18) and remove the twist.

 NOTE : If the hose is twisted it could restict the gas flow from the
____
 inflation reservoir to the escape slide.

 (8)
 Tighten the inflation hose attach-nut (18).

 (9)
 Put the escape-slide stowage compartment (5) in position and install and torque the panel attach studs (4) to between 0.35 and 0.45 m.daN

 (30.97 and 39.82 lbf.in).

 (10) If you install the escape-slide stowage compartment (5) below the left and/or right passenger/crew door 3, you must:
 (a) Put the belly fairing panel (2) in position.
 (b) Close the panel-attach latch mechanism (1). Subtask 25-62-47-710-050
 B. Test:
 (1) Do the operational test of the emergency lighting system (Ref. TASK 33-51-00-710-001).
 5. Close-up
________ Subtask 25-62-47-410-051
 A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Remove the lockpin assembly from the operating head of the inflation reservoir.

 (3)
 Put the lockpin assembly in the stowage pocket installed on the inflation reservoir (Ref. TASK 25-62-49-400-001).

 (4)
 Put the door back to the serviceable condition (Ref. TASK 52-22-00-860-004).

 (5)
 Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) from the flap/slat control lever.

 (6)
 Remove the warning notice(s).

 (7)
 Remove the access platform(s).

 (8)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 TASK 25-62-47-920-001 Escape-Slide Enclosure - Removal for Restoration
 1.
 Reason for the Job

__________________
 Refer to the MPD TASK: 256247-01

 2.
 Job Set-up Information

______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-62-47-000-001 Escape-Slide Enclosure - Removal 25-62-47-400-001 Escape-Slide Enclosure - Installation
 3. Job Set-up
__________ Subtask 25-62-47-020-051
 A. Get Access
 (1) Remove the escape-slide enclosure (Ref. TASK 25-62-47-000-001).
 4. Procedure
_________ Subtask 25-62-47-280-050
 A. Workshop Procedure
 (1) Do the restoration of the escape-slide enclosure. Refer to the manufacturers Component Maintenance Manual (CMM) for the correct procedures.
 5. Close-up
________ Subtask 25-62-47-420-052
 A. Close Access
 (1) Install a serviceable or replacement escape-slide enclosure (Ref. TASK 25-62-47-400-001).

 RELEASE MECHANISM - ESCAPE SLIDE, DOOR 2/3 - REMOVAL/INSTALLATION
_________________________________________________________________
 TASK 25-62-48-000-001
 Removal of the Emergency Escape-Slide Release-Mechanism Assembly
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice(s) No specific access platform(s) 3.4 m (11 ft. 2 in.) 98D52207551000 1 SAFETY PIN - SLIDE RELEASE LEVER 98D52207552000 1 RIGGING PIN - SLIDE RELEASE MECHANISM 98D52207553000 1 RIGGING PIN - SLIDE RELEASE MECHANISM
 B. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 25-23-47-000-004 Removal of the Door Frame Linings of the LH FWD Emergency Exit Door, zone 231 25-23-47-000-009 Removal of the Door Frame Linings of the RH FWD Emergency Exit Door, zone 232 25-23-47-000-010 Removal of the Door Frame Linings of the LH/RH AFT
 Emergency Exit Doors, zones 251/252. 25-62-49-000-001 Inflation Reservoir, Escape-Slide - Removal 25-80-00-000-001 Removal of the Insulation Blankets 52-22-00-010-001 Opening of the Emergency Exit Doors from the
 Passenger Compartment 52-22-00-010-002 Opening of the Emergency Exit Doors from the Outside 52-22-00-860-003 Special Precaution before Maintenance on the Door
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備4(135)