R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
TASK 25-65-00-720-001
Remove the Emergency Locator Transmitter for Workshop Test (Battery Check and Functional Check)
1.
Reason for the Job
__________________
Refer to the MPD TASK: 256532-01
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power
**ON A/C 001-049, 051-099, 101-149, 151-199, 201-299,
25-65-00-991-007 Fig. 503
**ON A/C 301-399,
25-65-00-991-007-A Fig. 503A R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
3. Job Set-up
__________
Subtask 25-65-00-861-052
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
R EFF : 001-049, 051-099, 101-149, 151-199, 25-65-00Page 511 201-299, 301-399, Aug 01/05
CES Subtask 25-65-00-010-053
B. Get Access
**ON A/C 001-049, 051-099, 101-149, 151-199, 201-299,
(Ref. Fig. 503/TASK 25-65-00-991-007)
**ON A/C 301-399,
(Ref. Fig. 503A/TASK 25-65-00-991-007-A) R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
(1)
Open the door/access panel of the stowage compartment(s). NOTE : The location of the ELT(s) are shown with placards, which are
____ bonded on the outside of the stowage compartment(s).
(2)
If necessary release/open the strap/clamp.
(3)
Remove the ELT(s) from the stowage compartment(s).
4. Procedure
_________
Subtask 25-65-00-720-050-A
A. Workshop Procedure
CAUTION : DO THE TEST IN THE SCREENED ROOM.
_______ IF THE SCREENED ROOM IS NOT AVAILABLE, DO THE TEST DURING THE FIRST FIVE MINUTES AFTER THE HOUR. (BETWEEN XX.00 HRS AND XX:05 HRS) IF YOU MUST DO THE TEST AT A DIFFERENT TIME, FIRST TELL THE NEAREST AIR TRAFFIC CONTROL FACILITY TO IGNORE THE SIGNAL DURING THE TEST. MAKE SURE THAT THE TEST SIGNAL IS NOT LONGER THAN THREE TONES. THIS IS TO PREVENT UNWANTED RESCUE OPERATIONS.
(1) Do a visual inspection, a battery check and a functional test of the ELT. Refer to the Manufacturers Component Maintenance Manual (CMM) for the correct procedures.
R EFF : 001-049, 051-099, 101-149, 151-199, 25-65-00Page 512 201-299, 301-399, Aug 01/05
CES
ELT - Component Location Figure 503/TASK 25-65-00-991-007
R EFF : 001-049, 051-099, 101-149, 151-199, 201-299, 25-65-00 Page 513 May 01/05
CES
R R ELT - Component Location Figure 503A/TASK 25-65-00-991-007-A
R EFF : 301-399, 25-65-00 Page 514 Nov 01/04
CES
5. Close-up
________ Subtask 25-65-00-410-054
A. Close Access
(1)
Install a serviceable or replacement ELT(s).
(2)
Attach/close the strap/clamp.
(3)
Close the door/access panel of the stowage compartment(s).
(4)
Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 25-65-00-862-052
B. De-energize the ground service network
(Ref. TASK 24-42-00-862-001).
R EFF : 001-049, 051-099, 101-149, 151-199, 25-65-00Page 515 201-299, 301-399, Aug 01/05
CES R **ON A/C 151-199, 211-228, 301-302,
TASK 25-65-00-720-004
Remove ELT for Battery Replacement and during Reinstallation Perform the
Functional Check of ELT System including Automatic Activation
1.
Reason for the Job
__________________
Refer to the MPD TASK: 256535-02
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設(shè)備4(156)
