On the ELT 110MX:
 -The RED indicator flashes one time, and the buzzer operates for 5 seconds.
 -After 3 seconds the RED indicator
 (12) comes on for approximately 3
 seconds.

 On the panel 108VU:
 -The ELT indicator 113MX comes on for 5 seconds.

 BITE Test - Component Location Figure 501/TASK 25-65-00-991-006- 12 (SHEET 1) 
R  EFF :  151-199, 211-228, 301-302,  25-65-00 Page 504 Feb 01/05
 CES 

 BITE Test - Component Location Figure 501/TASK 25-65-00-991-006- 22 (SHEET 2) 
R  EFF :  151-199, 211-228, 301-302,  25-65-00 Page 505 Feb 01/05
 CES 

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
2. On the ELT 110MX:
 -
Set the ON/OFF/ARM switch (11) to the OFF position.

 -
Set the ON/OFF/ARM switch (11) to the ARM position.

NOTE : A self-test mode is set
____ automatically for 5 seconds.
5. Close-up
________ Subtask 25-65-00-410-050
 A. Close Access In the nose-landing-gear well:
 -The mechanic call-horn 15WC operates for 5 seconds.
On the ELT 110MX:
-The RED indicator flashes one time, and the buzzer operates for 5seconds.
-After 3 seconds the RED indicator
(12) comes on for approximately 3
 seconds.

 On the RCP 111MX:
 -The ON/TEST indicator flashes one time.
 -After 3 seconds the ON/TEST indicator
 (18) comes on for approximately 3
 seconds.

 On the panel 108VU:
 -
The ELT indicator 113MX comes on for 5 seconds.

 In the nose-landing-gear well:

 -
The mechanic call-horn 15WC operates for 5 seconds.

 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Install the ceiling panel 261BC (Ref. TASK 25-23-42-400-002).

 (3)
 Remove the ground support and maintenance equipment, the special and

 standard tools and all other items. Subtask 25-65-00-862-051
 B. De-energize the ground service network (Ref. TASK 24-42-00-862-001).

 TASK 25-65-00-710-001
 Operational Check of Emergency Locator Transmitter (ELT) System by Manual Activation
 1.
 Reason for the Job

__________________
 Refer to the MPD TASK: 256535-01

 2.
 Job Set-up Information

______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001  Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power 25-65-00-991-009 Fig. 502
 3. Job Set-up
__________ Subtask 25-65-00-861-054
 A. Energize the ground service network
 (Ref. TASK 24-42-00-861-001).

 4. Procedure
_________ Subtask 25-65-00-710-050
 A. Operational Test
 (Ref. Fig. 502/TASK 25-65-00-991-009)

 (1) In the cockpit prevent damage to the ELT electronics: CAUTION : DO NOT DO AN ANNUNCIATOR LIGHT TEST DURING THE TEST OF THE
_______ EMERGENCY LOCATOR TRANSMITTER (ELT) SYSTEM. IF YOU DO, YOU CAN CAUSE DAMAGE TO AN INTERNAL RELAY OF THE ELT.

 Operational Test - Component Location Figure 502/TASK 25-65-00-991-009 
R  EFF :  151-199, 211-228, 301-302,  25-65-00 Page 509 Feb 01/05
 CES 

 (a) Make sure that on the panel 25VU the ANN LT switch (1) is not set to the TEST position during the operational test.
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the remote-control panel (RCP) 111MX:
 -Set the ON-ARMED-TEST/RESET switch (4) to the TEST/RESET position.
NOTE : The ON-ARMED-TEST/RESET
____ switch (4) goes back automatically to the ARMED position. A self-test mode is set automatically for 5 seconds.
5. Close-up________
 Subtask 25-65-00-862-054On the RCP 111MX:
-The ON/TEST indicator flashes onetime.
-After 3 seconds the ON/TEST indicator
 (3) comes on for approximately 3
seconds.

NOTE : You can ignore the indications
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備4(155)