曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Requirements for route For ATS route designator, enter published chart designator;
eg, B456, H62.
Route details must start with DCT (direct) to indicate the
flight is planned to track from the departure aerodrome
(YSCB for Canberra), to the first en route point, then from
the last en route point to the destination (YSSY for Sydney);
eg DCT CB SY DCT.
When planning to track direct from the departure
aerodrome to the destination aerodrome, ie without the
use of navigational aids, enter DCT only.
When operating outside a designated ATS route, enter DCT
followed by a significant point; eg DCT PH CKL BIU PH DCT
or DCT 1239S14325E 1300S14335E.
When operating in a designated ATS route, enter the name
of the location where the route is joined followed by the
route designator; eg on a flight departing Ceduna for
Griffith via the route designators J49 and B469 enter DCT
CD J149 WHA B469 in Item 15.
On survey work in a block or airspace, enter DCT followed
by significant points to the survey area, included the point
of commencement of survey, then the point of exit from
the survey area and the significant points to the
destination;
eg, DCT BN KCY GAY YGYM MC BN DCT.
169
Civil Aviation Safety Authority Australia
PRE-FLIGHT PLANNING FLIGHT
NOTIFICATION
09/2001
2 SECTION
NOTE CONTENTS
When planning to conduct survey work, a map of the
survey area must be provided to ATS with the flight
notification.
When planning survey work, write in Item 18(b) the
expected delay (DLA) at the commencement of survey;
eg DLA/GAY 0130 indicates a delay at Gayndah for 90
minutes.
Note1: A designated route begins and ends at the navaid
except where the departure or destination is not serviced
by a navaid.
Note 2: Pilots should refer to ENR 3.1 para 2 “Route
Specifications” and ENR 1.1 para 17 “Navigation
Requirements” when planning a route.
Requirements for change Enter the significant point where the change will
of speed/level occur, followed by an oblique stroke, the cruise speed
and the level; eg, AY/N0130A080. Both cruise speed and
level must be entered even if only one has changed.
Requirements for change Enter details of a change to flight rules following the
of flight rules entry in Items 8 of Y or Z.
Enter the location where the change will occur followed
by a space and VFR or IFR; eg YBAF VFR.
Can accommodate change in level; eg ROM/N0180A090
IFR.
Requirements for cruise Enter the letter C followed by an oblique stroke,
climb/ block level the point at which the cruise climb or reservation is
reservation planned to start, an oblique stroke, the speed to be
maintained during the cruise climb or reservation, AND
the two levels defining the layer to be occupied during
the cruise climb or block reservation, OR one level and
the word PLUS; eg C/FERET/N0380F370F390,
orC/FERET/N0380F370PLUS
Total EET
Enter Total estimated elapsed time of the flight as four figures
in hours and minutes; eg 0340 and include any aerial
work delay noted as DLA in Item 18(a).
170
Civil Aviation Safety Authority Australia
PRE-FLIGHT PLANNING FLIGHT
NOTIFICATION
09/2001
2 SECTION
NOTE CONTENTS
Item 18 (a)
Enter Other information relevant to a stage of the flight and information
about navaid training, block surveys and other plain language
remarks of significance.
EET Use EET/ to indicate EETs for flights along designated ATS routes at
compulsory reporting points and for flights outside designated ATS
routes at points approximately 30 minutes flying time or 200NM
apart. Enter EET/ followed by the designator, the elapsed time in
hours and minutes from the departure point to the significant
point, including any DLA time associated with airwork from the
last route segment, a space, and other point/time groups with a
space in between each one ie; eg EET/BN0035 MLY0100
GAY0204 indicated an elapsed time to Brisbane of 35 minutes,
Maleny 60 minutes and Gayndah 124 minutes.
DEP DEP/ when ZZZZ has been entered in Item 13 followed by latitude
and longitude or bearing and distance from a location with an
authorised abbreviation; eg DEP/BN090120
DEST DEST/ when ZZZZ has been entered in Item 13 followed by latitude
and longitude or bearing and distance from a location with an
authorised abbreviation eg, DEST/2730S1527E
ALTN ALTN/ when ZZZZ has been entered in item 13 followed by
lattitude and longitude or bearing and distance from a location
with an approved abbreviation; eg ALTN/2700S15320E.
DLA DLA/ When aerial work will be conducted at a location followed
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：VFR Flight Guide(139)