(3)
Remove the outboard flap leading edge panel 2 (Ref. TASK 27-54-62-000-003).
4. Procedure
_________
(Ref. Fig. 610/TASK 57-53-00-991-011)
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R 1EFF : 001-049, 051-056, 1 57-53-00Page 667 1 1 May 01/05 1 1 1CES 1
Outboard Flap
Figure 610/TASK 57-53-00-991-011
R 1EFF : 001-049, 051-056, 1 57-53-00Page 668 1 1 May 01/05 1 1 1CES 1 Subtask 57-53-00-110-066
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the external surfaces of the upper and lower skins and the front spar fitting.
Subtask 57-53-00-210-059
B. Inspection
(1) Examine the external parts of the front spar fitting that you can see. Make sure that:
-
there is no corrosion
-
there are no cracks
-the protective treatment is in the correct condition. NOTE : If necessary, refer to the ASRM (Ref. ASRM 575321) for the
____
correct repair procedure.
5. Close-up
________ Subtask 57-53-00-410-058
A. Close Access
(Ref. Fig. 610/TASK 57-53-00-991-011)
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the leading edge panel 2 (Ref. TASK 27-54-62-400-003).
(3)
Install the applicable access panels (Ref. TASK 57-55-11-400-001):
-for the left wing, install 532AT, 532CB
-for the right wing, install 632AT, 632CB. Subtask 57-53-00-865-092
B. Make sure that this(these) circuit breaker(s) is(are) closed:
6CV, 8CV.
Subtask 57-53-00-860-111
C. Aircraft Maintenance Configuration
(1) Fully retract the flaps (Ref. TASK 27-50-00-866-009).
R 1EFF : 001-049, 051-056, 1 57-53-00Page 669 1 1 May 01/05 1 1 1CES 1 Subtask 57-53-00-942-070
D. Removal of Equipment
(1)
Remove the warning notice(s).
(2)
Remove the access platform(s).
(3)
Remove the safety barriers.
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
R 1EFF : 001-049, 051-056, 1 57-53-00Page 670 1 1 May 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
TASK 57-53-00-220-005
Special Detailed Inspection of Outboard Flap, Internal Support at Track 3
including RIB6, Fitting at Front Spar and Internal Doubler, LH/RH
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Refer to the MPD TASK: 575312-02
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
No specific warning notices
No specific access platform 2.5 m (8 ft. 2 in.)
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-53-00Page 671 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 08-061A D DAN 220
ALUMINIUM FOIL ADHESIVE TAPE (Ref. 20-31-00)
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(84)
