R Subtask 57-52-00-010-068
R D. Get Access
R (1) Put the access platform in position below the zone 531(631).
R (2) Remove the applicable flap track fairing (Ref. TASK 57-55-11-000-
R 004):
R - for the left wing, remove 531AT, 531CB
R - for the right wing, remove 631AT, 631CB.
R (3) Put the spark-proof lamp adjacent to the inspection area.
R 4. Procedure_________
R (Ref. Fig. 617/TASK 57-52-00-991-017)
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______
R EDGE:
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
R - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.
R INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R Subtask 57-52-00-210-060
R A. Inspection.
R (1) Do an inspection of the drive strut, drive lever and attachment
R brackets of the flap track 2. Make sure that:
R - there is no damage
R - there is no corrosion
R - there are no cracks or scores
R - the surface protection is in the correct condition.
R NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the____
R correct repair procedure.
R Inboard Flap - Drive Strut, Drive Lever and Attachment Brackets - Inspection R Area R Figure 617/TASK 57-52-00-991-017
1EFF : 301-399, 1 57-52-00Page A604 1 1 May 01/04 1 1 1CES 1
R 5. Close-up________
R Subtask 57-52-00-410-070
R A. Close Access
R (1) Remove the spark-proof lamp from the inspection area.
R (2) Install the applicable flap track fairing (Ref. TASK 57-55-11-400-
R 004):
R - for the left wing, install 531AT, 531CB
R - for the right wing, install 631AT, 631CB.
R (3) Make sure that the work area is clean and clear of tool(s) and other
R items.
R Subtask 57-52-00-865-090
R B. Remove the safety clip(s) and the tag(s) and close this(these) circuit
R breaker(s):
R 6CV, 8CV.
R Subtask 57-52-00-860-056
R C. Aircraft Maintenance Configuration
R (1) Fully retract the flaps (Ref. TASK 27-50-00-866-009).
R Subtask 57-52-00-942-069
R D. Removal of Equipment
R (1) Remove the access platform(s).
R (2) Remove the safety barriers.
R (3) Remove the warning notice(s).
R (4) Remove the ground support and maintenance equipment, the special and
R standard tools and all other items.
R TASK 57-52-00-220-010
R Special Detailed Inspection of Inboard Double Slotted Flap, Internal Brackets
R at Track 2, LH/RH
R WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______
R START A TASK ON OR NEAR:
R - THE FLIGHT CONTROLS
R - THE FLIGHT CONTROL SURFACES
R - THE LANDING GEAR AND THE RELATED DOORS
R - COMPONENTS THAT MOVE.
R WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______
R GEAR.
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(38)
