R TASK 57-52-00-220-013
R Special Detailed Inspection of Inboard Double Slotted Flap, RIB6, LH/RH
R WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______
R START A TASK ON OR NEAR:
R - THE FLIGHT CONTROLS
R - THE FLIGHT CONTROL SURFACES
R - THE LANDING GEAR AND THE RELATED DOORS
R - COMPONENTS THAT MOVE.
R WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______
R GEAR.
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
R - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.
R INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R 1. Reason for the Job__________________
R Refer to the MPD TASK: 575241-01
R 2. Job Set-up Information______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------
R REFERENCE QTY DESIGNATION
R -------------------------------------------------------------------------------
R No specific circuit breaker(s) safety clip(s)
R No specific safety barriers
R No specific warning notice
R No specific access platform 2.5 m (8 ft. 2 in.)
R B. Consumable Materials
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R Material No. 08-061A D DAN 220
R ALUMINIUM FOIL ADHESIVE TAPE (Ref. 20-31-00)
R C. Referenced Information
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R 27-50-00-866-008 Extension of the Flaps on the Ground
R 27-50-00-866-009 Retraction of the Flaps on the Ground
R ASRM 575200 (for corrective action)
R NTM 575241 PART 9 (for corrective action)
R 57-52-00-991-027 Fig. 627
R 3. Job Set-up__________
R Subtask 57-52-00-941-080
R A. Safety Precautions
R (1) Put a warning notice on the flap/slat control lever (panel 114VU) to
R tell persons not to operate the flaps.
R (2) Put the safety barriers in position.
R Subtask 57-52-00-860-075
R B. Aircraft Maintenance Configuration
R WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE_______
R CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS
R AND/OR DAMAGE.
R (1) Fully extend the flaps (Ref. TASK 27-50-00-866-008).
R (2) Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is
R installed on the flap/slat control lever on the panel 114VU.
R Subtask 57-52-00-865-109
R C. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------
R PANEL DESIGNATION IDENT. LOCATION
R -------------------------------------------------------------------------------
R 49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07
R 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
R Subtask 57-52-00-010-078
R D. Get Access
R (1) Put the access platform in position below the inboard flap at zone
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(52)
