R TASK 57-51-37-000-005
R Removal of the Access Panels 575KB(675KB), 575LB(675LB), 575MB(675MB)
R WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______
R GEAR.
R WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______
R START A TASK ON OR NEAR:
R - THE FLIGHT CONTROLS
R - THE FLIGHT CONTROL SURFACES
R - THE LANDING GEAR AND THE RELATED DOORS
R - COMPONENTS THAT MOVE.
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
R - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.
R INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R 1. Reason for the Job__________________
R Self Explanatory
R 2. Job Set-up Information______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------
R REFERENCE QTY DESIGNATION
R -------------------------------------------------------------------------------
R No specific safety barriers
R No specific warning notices
R No specific adjustable access platform 4 m (13 ft. 1 in.)
R 98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
R B. Referenced Information
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R 27-50-00-866-009 Retraction of the Flaps on the Ground
R 57-51-37-991-006 Fig. 406
R 3. Job Set-up__________
R Subtask 57-51-37-941-058
R A. Safety Precautions
R (1) Put the safety barriers in position.
R (2) Make sure that the flaps/slats are fully retracted (Ref. TASK 27-50-
R 00-866-009).
R (3) Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001)
R on the flap/slat control lever.
R (4) Put the warning notices in the cockpit to tell persons not to operate
R the flaps or slats.
R Subtask 57-51-37-010-055
R B. Get Access
R (1) Put the adjustable access platform below the applicable access panel,
R zone 575(675).
R 4. Procedure_________
R (Ref. Fig. 406/TASK 57-51-37-991-006)
R Subtask 57-51-37-020-053
R A. Removal of the Access Panels 575KB(675KB), 575LB(675LB), 575MB(675MB)
R (1) For the access panel 575KB(675KB):
R (a) Remove the fifteen bolts (2) then remove the access panel (1).
R (2) For the access panel 575LB(675LB):
R (a) Remove the fifteen bolts (6) then remove the access panel (5).
R (3) For the access panel 575MB(675MB):
R (a) Remove the ten bolts (11) then remove the access panel (10).
INTENTIONALLY BLANK
1 1
57-51-37Page 445
1 1 May 01/05 1 1 1CES 1R Lower Trailing Edge Access Panels - Rib 22 to Rib 27 R Figure 406/TASK 57-51-37-991-006- 14 (SHEET 1)
1EFF : ALL 1 57-51-37Page 446 1 1 May 01/05 1 1 1CES 1R Lower Trailing Edge Access Panels - Rib 22 to Rib 27 R Figure 406/TASK 57-51-37-991-006- 24 (SHEET 2)
1EFF : ALL 1 57-51-37Page 447 1 1 May 01/05 1 1 1CES 1R Lower Trailing Edge Access Panels - Rib 22 to Rib 27 R Figure 406/TASK 57-51-37-991-006- 34 (SHEET 3)
1EFF : ALL 1 57-51-37Page 448 1 1 May 01/05 1 1 1CES 1R Lower Trailing Edge Access Panels - Rib 22 to Rib 27 R Figure 406/TASK 57-51-37-991-006- 44 (SHEET 4)
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(5)
