R (4) If you can not install the rigging pin (202), adjust the length of
R the link rod (215) as follows:
R (a) If required, cut and remove the lockwire and loosen the jam nuts
R (213).
R (b) Turn the rod (214) until you can install the rigging pin (202)
R into the door structure.
R (c) Tigthen the jam nuts (213) and safety them with the lockwire,
R corrosion resistance steel, dia 0.8 mm (0.30 in.) on the locking
R devices (212).
R (5) Make sure that the clearance between the target of the actuation
R lever (207) and the proximity sensor 5WN or 6WN is correctly adjusted
R (Ref. TASK 52-71-00-820-009).
R (6) Measure the distance "N" between the head of the stop bolt (203) and
R the actuation lever (207).
R NOTE : The distance "N" must be between 0.2 mm (0.0078 in.) and 0.4____
R mm (0.0157 in.).
R (7) If the distance "N" is out of tolerance, adjust the stop bolt (203)
R as follows:
R (a) Remove the nut (206) and the stop bolt (203) together with the
R washers set (204) from the stop fitting (205).
R (b) Prepare the thickness of the washers set (204) so that the
R distance "N" is correct.
R (c) Install the stop bolt (203) together with the washers set (204)
R and the nut (206).
R (8) Pull up the slide control handle (187) in the disarmed position and
R safety it with the PIN - SAFETY SLIDE (98A52107632000).
R (9) Measure the distance "R" between the forward edge of the
R override-clutch release lever (218) and the release lever pin (217).
R NOTE : The distance "R" must be between 10.0 mm (0.3937 in.) and 14.0____
R mm (0.5511 in.).
R (10) If the distance "R" is out of tolerance, adjust the length of the
R connection rod (211) as follows:
R (a) If required, cut and remove the lockwire and loosen the jam nuts
R (208).
R (b) Turn the rod (210) until the clearance "R" is correct.
R (c) Tigthen the jam nuts (208) and safety them with the lockwire,
R corrosion resistance steel, dia 0.8 mm (0.30 in.) on the locking
R devices (209).
R (11) Make sure that the release travel between the release lever (233) of
R the door damper and the operation lever (231) is correct (refer also
R para.C.).
R (Ref. Fig. 518/TASK 52-22-00-991-029)
R (12) Measure the distance "S" between the rivet head (219) of the
R override-clutch release lever (218) and the stop (220).
R NOTE : The distance "S" must be between 1.4 mm (0.0551 in.) and 3.4____
R mm (0.1338 in.).
R (13) If the distance "S" is out of tolerance, add or remove the washer of
R the washer set (221) as required.
R NOTE : If required, use a new universal AL-rivet, dia. 4,8 mm (0.19____
R in.) (219).
R (14) Do the subsequent clearance check after a "simulated emergency
R opening":
R NOTE : In the "simulated emergency opening"____
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門3(77)
