3. Job Set-up
__________ Subtask 52-13-00-861-050
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
Subtask 52-13-00-010-061
B. Get Access WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
THAN 65 KNOTS.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
(1)
Put an access platform in position in front of the passenger/crew door 832 or 842.
(2)
Open the applicable passenger/crew door (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).
Subtask 52-13-00-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
1EFF : ALL 1 52-13-00Page 506 1 1 May 01/05R 1 1 1CES 1
**ON A/C 001-002,
Subtask 52-13-00-010-051-B
D. Removal of Components
(1)
Remove the lining flap (Ref. TASK 52-13-31-000-001).
(2)
Remove the escape slide (Ref. TASK 25-62-44-000-002).
(3)
Remove the door lining panels (Ref. TASK 25-23-46-000-002):
(a)
For the left door: 832FZ, 832CZ, 832DZ, 832AZ, 832BZ, 832EZ, 832GZ.
(b)
For the right door: 842FZ, 842CZ, 842DZ, 842AZ, 842BZ, 842EZ, 842GZ.
(4)
Remove the door-frame lining panels:
(a)
For the left door: 261TW, 261UW, 261VW, 261WW (Ref. TASK 25-23-45-000-003).
(b)
For the right door: 262TW, 262UW, 262VW, 262WW (Ref. TASK 25-23-45-000-004).
(5) Remove the door insulation blankets. Subtask 52-13-00-420-053-B
E. Installation of the Ballast Weight
(1) Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000) (Ref. TASK 52-10-00-480-001).
NOTE : If no ballast weight is available, it is permitted to use the
____ escape slide on the door during the adjustment (as an alternative to BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000)). If you do this, make sure that the escape slide lets you have access for the adjustment procedure.
R 1EFF : 001-002, 1 52-13-00Page 507 1 1 May 01/05 1 1 1CES 1R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 52-13-00-010-051-C
D. Removal of Components
(1)
Remove the lining flap (Ref. TASK 52-13-31-000-001).
(2)
Remove the escape slide/raft (Ref. TASK 25-62-44-000-002).
(3)
Remove the door lining panels (Ref. TASK 25-23-46-000-002):
(a)
For the left door: 832FZ, 832CZ, 832DZ, 832AZ, 832BZ, 832EZ, 832GZ.
(b)
For the right door: 842FZ, 842CZ, 842DZ, 842AZ, 842BZ, 842EZ, 842GZ.
(4)
Remove the door-frame lining panels:
(a)
For the left door: 261TW, 261UW, 261VW, 261WW (Ref. TASK 25-23-45-000-003).
(b)
For the right door: 262TW, 262UW, 262VW, 262WW (Ref. TASK 25-23-45-000-004).
(5) Remove the door insulation blankets.
Subtask 52-13-00-420-053-C
E. Installation of the Ballast Weight
(1) Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000) (Ref. TASK 52-10-00-480-001).
NOTE : If no ballast weight is available, it is permitted to use the
____ escape slide/raft on the door during the adjustment (as an alternative to BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000)). If you do this, make sure that the escape slide/raft lets you have access for the adjustment procedure.
R 1EFF : 003-049, 051-099, 101-149, 151-199, 1 52-13-00Page 508 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1 1EFF : ALL 1 52-13-00Page 509 1 1 May 01/05 1 1 1CES 1
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門2(59)
