1EFF : ALL 1 52-13-14Page 505 1 1 May 01/02 1 1 1CES 1

 CYLINDER - DOOR DAMPER AND EMERGENCY OPERATION - INSPECTION/CHECK
_________________________________________________________________
 TASK 52-13-14-200-001
 Inspection/Check of the Damper and Emergency Operation Cylinder of the Aft
 Passenger/Crew Door
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
 No specific access platform 4.4 mm (0.1732 in.)
 B. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
25-23-46-000-002 Removal of the Door Linings at the AFT Passenger/Crew Doors 25-23-46-400-002 Installation of the Door Linings at the AFT
 Passenger/Crew Doors
 52-10-00-010-001 Opening of the Passenger/Crew Door
 52-10-00-410-001 Closing of the Passenger/Crew Door

R 52-10-00-614-001 Discharging/Charging of the Damper and Emergency R Operation Cylinder of the Passenger/Crew Doors 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew Door 52-10-00-860-002 Special Precautions after Work on the Passenger/Crew Door 52-13-14-991-005 Fig. 601
 1EFF : ALL 1 52-13-14Page 601 1 1 May 01/03 1 1 1CES 1

 3. Job Set-up
__________ Subtask 52-13-14-010-069
 A. Get Access WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
 THAN 65 KNOTS.

 WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
 -
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.

 -
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.

 WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
 (1)
 Put the access platform in position in front of the passenger/crew door 832 or 842.

 (2)
 Open the passenger/crew door 832, 842 (Ref. TASK 52-10-00-010-001).

 (3)
 Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).

 Subtask 52-13-14-865-050
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
 Subtask 52-13-14-010-070
 C. Removal of Component.
 (1) Remove the support arm lining panels:
 (Ref. TASK 25-23-46-000-002).

 (a) For the left passenger/crew door 832FZ, 832GZ.
 1EFF : ALL 1 52-13-14Page 602 1 1 Feb 01/98 1 1 1CES 1

 (b) For the right passenger/crew door 842FZ, 842GZ.
 4. Procedure
_________ Subtask 52-13-14-210-051
 A. Inspection of the Door Damper and Emergency Operation Cylinder.
 (Ref. Fig. 601/TASK 52-13-14-991-005)

 (1)
 Make sure that the door is open.

 (2)
 Do a visual inspection of the the door-damper and emergency-operation cylinder. Make sure that there are no fluid leakage, corrosion, cracks, marks or dents and that the components are correctly attached.

 (3)
 Do a visual inspection of the paint. Make sure that the paint is not flaked or peeled.

 (4)
 Check of the Pressure. CAUTION : THE PRESSURE ON THE PRESSURE INDICATOR OF THE BOTTLE MUST

_______ BE RELATED TO THE PRESSURE CORRECTED FOR TEMPERATURE.
 (a)
 Write the pressure value shown on the pressure gauge (1).

 (b)
 Compare this value with the value on the placard (2) for the ambient temperature.

 NOTE : Let the air bottle stabilize to the ambient temperature
____ before you do the inspection. This is to get a correct pressure value.
 NOTE : Bubbles in the pressure gauge with a maximum diameter
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門2(103)