(3)
 Interface with the Speedbrake Control Transducer Unit. (Ref. Fig. 009) The Speedbrake Control Transducer Unit has two sets of three-tracks potentiometers. The COM unit of each SEC is connected to one potentiometer of one set, the MON unit is connected to one potentiometer of the other set.

 (4)
 Interface with RVDT or LVDT 6 wire transducers (ANI 2) : for surface position transducer. 4 wire transducers: (ANI 3) : for servovalve position transducer, (ANI 7) : for servo-actuator mode transducer.

 (5)
 Interface with the wheel tachometer. (Ref. Fig. 010) Each main landing gear wheel is fitted with a tachometer that transmits wheel speed information to the SEC COM and MON units (ANI 6).

 (6)
 Interface with the accelerometers. (Ref. Fig. 011) Each accelerometer is connected to the COM and MON units of one SEC (ANI 4). Each SEC is connected to two accelerometers.

 SEC Links (General)
 Figure 006
 1EFF :  ALL  1  27-94-00 Page 8 
1  1  Feb 01/98
 1  1
 1CES  1

 Side Stick Transducer Unit
 Figure 007
 1EFF :  ALL  1  27-94-00 Page 9 
1  1  Feb 01/98
 1  1
 1CES  1

 Throttle Control Units
 Figure 008
 1EFF :  ALL  1  27-94-00 Page 10 
1  1  Feb 01/98
 1  1
 1CES  1

 Speedbrake Control Transducer Unit
 Figure 009
 1EFF :  ALL  1  27-94-00 Page 11 
1  1  Feb 01/98
 1  1
 1CES  1

 Tachometers
 Figure 010
 1EFF :  ALL  1  27-94-00 Page 12 
1  1  Feb 01/98
 1  1
 1CES  1

 Accelerometers
 Figure 011
 1EFF :  ALL  1  27-94-00 Page 13 
1  1  Feb 01/98
 1  1
 1CES  1

 B. Discrete Interface
 (1)
 Interface with pressure switches. (Ref. Fig. 012) Each SEC COM and MON unit is directly connected to one switch per system.

 (2)
 Interface with the SFCC.

 (Ref. Fig. 013) R One discrete signal is transmitted from each SFCC slat channel to the R SEC: R - slat position equal to or greater than 17 deg.: ground R - slat position less than 17 deg.: open circuit
 (3)
 Ground Spoilers extended. (Ref. Fig. 014) Each SEC unit sends to the BSCU and ELAC the discrete signal (DS07) : Ground spoilers extended.

 (4)
 Interface with the ELACs. (Ref. Fig. 015, 016) The DGI 9 and DGI 11 (Ref. ARINC interface) digital data are validated by the discrete data DSI 14 and DSI 21 on each unit. The SEC sends and receives discrete information for pitch priority (Ref. Fig. 017, 018)

 (5)
 Interface with the other SECs
 (Ref. Fig. 019, 020)

 C. ARINC Interface
 (1)
 Interface with the LGCIU. (Ref. Fig. 021) Each SEC command and monitor unit receives (DGI 14) an ARINC 429 data-bus discrete word using the landing gear up/down information.

 (2)
 Interface with the SFCC. (Ref. Fig. 022) The SEC COM and MON units use the digital information from the SFCC for configuration determination

 (3)
 Interface with the ADIRS. (Ref. Fig. 023, 024) The connections of the ADIRS to the SEC consist of two ARINC 429 data buses transmitted from each ADC and two buses transmitted from each IRS.

 (4)
 SERVO DRIVE board
 The SERVO DRIVE board performs the functions below :

 Pressure Switches
 Figure 012
 1EFF :  ALL  1  27-94-00 Page 15 
1  1  Feb 01/98
 1  1
 1CES  1

R R  SFCC/ELAC-SEC (Discrete) Figure 013
 1EFF : 1 1 1CES  ALL  1 111 27-94-00 Page 16 Feb 01/02

 SEC Discrete Output: GND SPLR ON
 Figure 014
 1EFF :  ALL  1  27-94-00 Page 17 
1  1  Feb 01/98
 1  1
 1CES  1

 ELAC Discrete Output: DGO 1 Validation
 Figure 015
 1EFF :  ALL  1  27-94-00 Page 18 
1  1  Feb 01/98
 1  1
 1CES  1

 ELAC DIGITAL OUTPUT 1 (ARINC 429)
 Figure 016
 1EFF :  ALL  1  27-94-00 Page 19 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱9(81)