(2)
Remove the warning notice(s).
(3)
Install the panel 211GF at zone 211 (Ref. TASK 53-12-11-400-001).
(4)
Close the access door 811.
(5)
Remove the access platform(s).
SIDE STICK ASSEMBLY (4CE1,4CE2,4CE3,4CE4,8CE1,8CE2) - REMOVAL/INSTALLATION
__________________________________________________________________________
TASK 27-92-41-000-001
Removal of the Side Stick Assembly 19VU (18VU)
WARNING : MAKE SURE THAT THE SIDE STICK ASSEMBLY STAYS IN THE VERTICAL POSITION
_______
DURING THE MAINTENANCE PROCEDURES.
IF NOT THERE IS A RISK OF SKYDROL LEAKAGE.
SKYDROL CAN CAUSE INJURY AND/OR DAMAGE.
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps
No specific circuit breaker(s) safety clip(s)
No specific warning notice
No specific access platform 1.6 m (5 ft. 3 in.)
98D27903500000 1 PIN-SIDE STICK LOCKING
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power
**ON A/C 001-049, 051-099, 101-105, 151-158, 201-210,
27-92-41-991-001 Fig. 401 R **ON A/C 106-149, 159-199, 211-299, 301-399, 401-499,
27-92-41-991-001-A Fig. 401A -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C ALL
27-92-41-991-002-A Fig. 402
3. Job Set-up
__________
Subtask 27-92-41-861-052
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
Subtask 27-92-41-010-065
B. Get Access
(1)
Put the access platform in position at the access door 822.
(2)
Open the access door 822.
(3)
On the battery power center 105VU:
-loosen the two screws and remove the protective cover.
Subtask 27-92-41-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/ELAC1/NORM/SPLY 15CE1 B11 49VU FLIGHT CONTROLS/SEC1/NORM/SPLY 21CE1 B08 49VU COM/AUDIO/ACP/F/O 5RN G07 49VU COM/AUDIO/ACP/CAPT 4RN G06 105VU FLIGHT CONTROLS/ELAC2/STBY SPLY 16CE2 A02 105VU FLT CTL/ELAC1/STBY SPLY 16CE1 A01 105VU FLT CTL/SEC1/STBY SPLY 22CE B01 121VU AUTO FLT/STICK/LOCK 13CA N16 121VU FLIGHT CONTROLS/SEC3/SPLY 21CE3 Q19 121VU FLIGHT CONTROLS/SEC2/SPLY 21CE2 Q18 121VU FLIGHT CONTROLS/ELAC2/NORM/SPLY 15CE2 R20
**ON A/C 001-049, 051-099, 101-105, 151-158, 201-210,
Subtask 27-92-41-010-050
D. Removal of the Cover panel.
(Ref. Fig. 401/TASK 27-92-41-991-001)
(1)
Release the lock (8) and remove the handle (1).
(2)
Remove the screws (4), the screw (6), the washers (5) and the washer (7).
(3) Release the catches (2) and remove the cover (3). R **ON A/C 106-149, 159-199, 211-299, 301-399, 401-499,
Subtask 27-92-41-010-050-A
D. Removal of the Cover panel.
(Ref. Fig. 401A/TASK 27-92-41-991-001-A)
(1)
Remove the screws (8) and the handle (1).
(2)
Remove the screws (4), the screw (6), the washers (5) and the washer (7).
(3) Remove the screws (2) and the cover (3).
**ON A/C ALL
Subtask 27-92-41-480-050
E. Installation of the Tools
(1)
Put the PIN-SIDE STICK LOCKING (98D27903500000) (10) in position on the central universal joint. (Ref. Fig. 402/TASK 27-92-41-991-002-A)
(2)
Put warning notice on the side stick to tell persons not to operate the side stick.
Cover Panel
Figure 401/TASK 27-92-41-991-001
R 1EFF : 001-049, 051-099, 101-105, 151-158, 1 27-92-41Page 404 1201-210, 1May 01/05 1 1 1CES 1 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱9(41)
