(2)
Install the upper and lower kink-seals (1) and (2) to the inboard and the outboard flaps (Ref. TASK 27-54-61-400-006).
(3)
Make sure that the flaps are fully retracted (Ref. TASK 27-50-00-866-009).
Subtask 27-51-44-710-060
E. Test
(1) Do an operational test of the flap system (Ref. TASK 27-54-00-710-001).
Subtask 27-51-44-942-058
F. Removal of Equipment
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the safety barriers.
(3)
Remove the warning notice(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
BRAKE - WING TIP (WTB) (33CV,34CV) - REMOVAL/INSTALLATION_________________________________________________________
TASK 27-51-51-000-001
Removal of the Flap Wing-Tip Brake
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND THE RELATED DOORS - COMPONENTS THAT MOVE.
WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES._______
R R R R R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______ - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job__________________
Self Explanatory
2. Job Set-up Information______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific No specific No specific No specific No specific No specific 98D27504030001 98D27604000000 98D27803000000 blanking capsblanking plugscircuit breaker(s) safety clip(s)safety barrierswarning noticeaccess platform 3 m (9 ft. 10 in.)2 LOCK-TORQUE SHAFT (FLAPS AND SLATS) WITH CLAMP-PIVOT1 COLLAR-SAFETY, SPOILER1 LOCKING TOOL - FLAP/SLAT CONTROL LEVER
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R R R R R R R R 27-50-00-400-003 27-50-00-866-008 27-54-45-000-008 27-54-45-000-011 27-60-00-866-002 29-10-00-864-001 29-10-00-864-002 29-10-00-864-003 29-14-00-614-001 27-51-51-991-001 FOR FIN 33CV 57-51-37-000-004 FOR FIN 34CV 57-51-37-000-004 Installation of the Lock-Torque Shaft - Flaps and Slats (98D27504030001)Extension of the Flaps on the GroundRemoval of the Torque Shafts 6216CM(6266CM)/6226CM(6276CM)Removal of the Torque Shafts 6224CM(6274CM)/6230CM(6280CM)Extension-Retraction of the Spoilers for MaintenanceDepressurize the Green Hydraulic SystemDepressurize the Yellow Hydraulic SystemDepressurize the Blue Hydraulic SystemDepressurization of the Hydraulic ReservoirsFig. 401 Removal of the Access Panels 575AB/575BB/575CB/575DB/575EB/575FB/575GB/575HB (675AB/675BB/675CB/675DB/675EB/675FB/675GB/675HB) Removal of the Access Panels 575AB/575BB/575CB/575DB/575EB/575FB/575GB/575HB (675AB/675BB/675CB/675DB/675EB/675FB/675GB/675HB)
3. Job Set-up__________
(Ref. Fig. 401/TASK 27-51-51-991-001)
Subtask 27-51-51-941-059
A. Safety Precautions
(1) Put the safety barriers in position.
(2) Put a warning notice in the cockpit to tell persons not to pressurize the hydraulic systems.
(3) Put a warning notice in position to tell persons not to operate the flight controls.
Flap Wing-Tip Brake 33CV(34CV)
Figure 401/TASK 27-51-51-991-001
1EFF : ALL 1 27-51-51 Page 403
1 1 Feb 01/98
1 1
1CES 1
Subtask 27-51-51-860-050
B. Aircraft Maintenance Configuration
(1)
Extend the flaps fully (Ref. TASK 27-50-00-866-008).
(2)
Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER on the flap/slat control lever.
(3)
Depressurize the Green, Yellow and Blue hydraulic systems (Ref. TASK 29-10-00-864-001) (Ref. TASK 29-10-00-864-002) and (Ref. TASK 29-10-00-864-003).
(4)
Depressurize the reservoirs of the Green, Yellow and Blue hydraulic systems. (Ref. TASK 29-14-00-614-001).
(5)
Remove the safety collar from the circuit breakers 10CV and 12CV.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱4(123)
