曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

D. Location Zones
Zone Area
133 Main Landing Gear Wheel Well, Body Station 663.75 to Body Station
727.00 - Left
134 Main Landing Gear Wheel Well, Body Station 663.75 to Body Station
727.00 - Right
541 Left Wing - Fairing Flap Support No. 4
641 Right Wing - Fairing Flap Support No. 5
E. Prepare for the Removal
SUBTASK 27-51-15-860-003
(1) Extend the trailing edge flaps to the 40-unit position. To extend them, do this task: Extend the
Trailing Edge Flaps, TASK 27-51-00-860-803.
SUBTASK 27-51-15-480-001
WARNING: MAKE SURE THE DOWNLOCK PINS ARE INSTALLED ON ALL THE LANDING GEAR.
WITHOUT THE DOWNLOCK PINS, THE LANDING GEAR CAN RETRACT AND CAUSE
INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(2) If the downlock pins are not installed in the nose and main landing gear, do this task: Landing
Gear Downlock Pins Installation, TASK 32-00-01-480-801.
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-51-15
Page 410
Oct 10/2006
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
SUBTASK 27-51-15-040-002
(3) Do this task: Trailing Edge Flap System Deactivation, TASK 27-51-00-040-801.
SUBTASK 27-51-15-020-007
(4) Do this task: Inboard Trailing Edge Flap Removal, TASK 27-51-11-000-801.
SUBTASK 27-51-15-020-008
(5) Do this task: Inboard Flap Inboard Skew Mechanism Removal, TASK 27-59-02-000-804.
SUBTASK 27-51-15-020-009
(6) Do this task: Inboard Flap Inboard Transmission Removal, TASK 27-51-31-000-802.
F. Inboard Flap Inboard Track Removal
NOTE: Make sure you support the flap track assemblies [41] while you disconnect it.
SUBTASK 27-51-15-480-005
(1) If you will use the adapter, SPL-1733, install it on the flap track assemblies [41]:
(a) Install the adapter, SPL-1733 on the flap track assemblies [41] approximately 20 inches (50
cm) aft of the track forward attach fitting.
(b) Put a low profile hydraulic jack, COM-1568 below the adapter, SPL-1733 to support the flap
track assemblies [41].
SUBTASK 27-51-15-020-010
(2) Disconnect the link assembly [45] from the structure:
(a) Remove the nut [43], washer [42] and bolt [46] from the bolt [49].
(b) Remove the nut [48] and washer [47] from the bolt [49].
(c) Remove the bolt [49] that attaches the link assembly [45] to the structure.
SUBTASK 27-51-15-020-011
(3) Disconnect the forward end of the flap track assemblies [41]:
(a) Remove the nut [56], washer [55] and bolt [52] that attach the flap track assemblies [41] to
the forward attach assembly [50].
(b) Remove the nut [58], washer [54] and bolt [51] that attach the flap track assemblies [41] to
the forward attach assembly [50].
SUBTASK 27-51-15-020-012
(4) If you will install a new flap track assemblies [41], remove the transmission attach fitting [53] and
the link assembly [45] from the flap track assemblies [41]:
(a) Remove the bolts [60], bolt [64], washers [61] and nuts [62] that attach the transmission
attach fitting [53] to the flap track assemblies [41].
(b) Disconnect the link assembly [45] from the flap track assemblies [41]:
1) Remove the nut [67], washer [65] and bolt [68] from the bolt [72].
2) Remove the nut [71], washer [70] and washer [69] from the bolt [72].
3) Remove the bolt [72] that attaches the link assembly [45] to the flap track
assemblies [41].
------------------------- END OF TASK ---------------------------
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-51-15
Page 411
Oct 10/2006
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Inboard Flap Inboard Flap Track Installation
Figure 402 (Sheet 1 of 4)/27-51-15-990-802
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-51-15
Page 412
Oct 10/2003
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Inboard Flap Inboard Flap Track Installation
Figure 402 (Sheet 2 of 4)/27-51-15-990-802
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-51-15
Page 413
Oct 10/2003
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Inboard Flap Inboard Flap Track Installation
Figure 402 (Sheet 3 of 4)/27-51-15-990-802
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-51-15
Page 414
Oct 10/2007
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Inboard Flap Inboard Flap Track Installation
Figure 402 (Sheet 4 of 4)/27-51-15-990-802
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600-700-800-900 AIRCRAFT MAINTENANCE MANUAL飛機維護手冊4(117)