(2)
Put the safety barriers in position.
(3)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
(4)
Put an access platform in position below the applicable wing-tip:
-
for the left wing, below zone 534.
-
for the right wing, below zone 634.
Subtask 57-31-00-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU LIGHTING/EXT LT/NAV1/AND LOGO/LT 1LA T03 122VU LIGHTING/EXT LT/NAV2/AND LOGO/LT 2LA T02 122VU LIGHTING/WING/STROBE 10LV V05
4. Procedure
_________
(Ref. Fig. 401/TASK 57-31-00-991-001)
Subtask 57-31-00-110-050
A. Preparation for Deactivation
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-004) to clean the area around the damage.
Subtask 57-31-00-040-050
B. Deactivation of the Wing-tip Fence
(1)
Examine the wing tip and the wing-tip fence.
(2)
If the damage extends to the wing-tip, replace the wing-tip (Ref. TASK 57-31-21-000-001) (Ref. TASK 57-31-21-400-001) and the wing-tip fence (Ref. TASK 57-31-22-000-001) (Ref. TASK 57-31-22-400-001).
(3)
If the damage is confined to the maximum area (Ref. Fig. 401), do the steps that follow:
(a) If necessary, remove sharp and/or badly damaged contours on the edges of the wing-tip fence.
NOTE : Damage to the structure that attaches the wing-tip fence
____ to the wing-tip is not permitted. Damage to the cast nose piece is not permitted.
(b) Apply a layer of BONDING AND ADHESIVE COMPOUNDS (Material No. 08-061A) to temporarily repair the wing tip fence.
R Wing-Tip Fence Repairable Area Figure 401/TASK 57-31-00-991-001
1EFF : 1 1 1CES ALL 1 111 57-31-00 Page 404 May 01/98
(4)
If the damage is more than the maximum area (Ref. Fig. 401), do the steps that follow:
(a)
Remove the wing-tip fence (Ref. TASK 57-31-22-000-001).
(b)
Apply a layer of BONDING AND ADHESIVE COMPOUNDS (Material No. 08-061A) to cover the aircraft internal structure.
(5)
Put a warning notice in the cockpit to tell persons that:
-
the wing-tip fence has been deactivated
-
the aircraft performance is decreased to the limits given in the CDL.
(6)
Write down in the aircraft log that the wing-tip fence has been deactivated.
5. Close-up
________ Subtask 57-31-00-865-051
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU LIGHTING/EXT LT/NAV1/AND LOGO/LT 1LA T03 122VU LIGHTING/EXT LT/NAV2/AND LOGO/LT 2LA T02 122VU LIGHTING/WING/STROBE 10LV V05
Subtask 57-31-00-942-051
B. Removal of Equipment
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the access platform(s).
(3)
Remove the safety barriers.
(4)
Remove the warning notices from the cockpit that tell persons not to operate the flaps or slats.
(5)
Remove the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER from the flap/slat control lever.
(6)
Remove the ground support and maintenance equipment, the special and
standard tools and all other items.
TASK 57-31-00-440-001
Reactivation of the Wing-Tip Fence
1. Reason for the Job__________________
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼2(93)
