(2)
Keep the panels vertical to drain.
(3)
Let the panels drain for the maximum available time until no leakage of fluid is seen.
(4)
Remove the panels from the transparent plastic bag.
(5)
Clean the panels with CLEANING AGENTS (Material No. 11-026) and a MISCELLANEOUS (Material No. 19-003).
(6)
Apply SEALANTS (Material No. 09-002):
- on the rivet heads at all the rivnut positions
-around the plugs.
(7)
When the sealant is tack free, install the panels (Ref. TASK 57-27-11-400-001).
5. Close-up
________ Subtask 57-27-11-942-061
A. Removal of Equipment
(1)
Discard the unwanted fluid and the used transparent plastic bags in accordance with local regulations.
(2)
Make sure that the work area is clean and clear of tools and other items.
R 1EFF : 001-049, 051-061, 101-105, 151-151, 1 57-27-11Page 802 1201-203, 1May 01/05 1 1 1CES 1 DOOR - ACCESS, FUEL SURGE - REMOVAL/INSTALLATION
________________________________________________
TASK 57-27-12-000-001
Removal of the Fuel-Surge Access Panel
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific safety barriers
No specific warning notices
No specific access platform 2.8 m (9 ft. 2 in.)
98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
98D57004013000 1 HOOK-COVER (RIB 2 SURGE DOORS)
98D57004014000 1 HOOK-COVER (RIB2-SURGE DOORS)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-10-00-910-001 Safety Procedures When You Do Work in a Fuel Tank 28-10-00-910-002 Access to the Fuel Tanks and the Work Areas 28-25-00-650-001 Pressure Defuel 28-25-00-650-003 To Drain Remaining Fuel from the Wing Tanks and the
Center Tank
57-27-11-000-001 Removal of the Access Panel (540AB, 540BB, 540CB, 540DB, 540EB, 540FB, 540GB, 640AB, 640BB, 640CB, 640DB, 640EB, 640FB, 640GB)
57-27-12-991-001 Fig. 401
3. Job Set-up
__________ Subtask 57-27-12-941-050
A. Safety Precautions WARNING : OBEY THE SAFETY PROCEDURES WHEN YOU DO WORK IN A FUEL TANK.
_______
(1)
Obey the fuel safety procedures when you do work in a fuel tank (Ref. TASK 28-10-00-910-001).
(2)
Put the safety barriers in position.
(3)
Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) on the flap/slat control lever.
(4)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
Subtask 57-27-12-650-052
B. Fuel Configuration
(1)
Defuel the aircraft (Ref. TASK 28-25-00-650-001).
(2)
Drain the remaining fuel from the applicable fuel tank(s) (Ref. TASK 28-25-00-650-003).
Subtask 57-27-12-010-050
C. Get Access
(1)
Put the access platform in position below the wing fuel tank, zone 540 (640).
(2)
Remove the applicable access panel (Ref. TASK 28-10-00-910-002) (Ref. TASK 57-27-11-000-001):
-
for the left wing, remove 540AB
-
for the right wing, remove 640AB.
(3)
For the forward fuel-surge access panel:
- open the aft fuel-surge access panel and keep it open with the HOOK-COVER (RIB2-SURGE DOORS) (98D57004014000).
(4)
For the aft fuel-surge access panel:
- open the forward fuel-surge access panel and keep it open with the HOOK-COVER (RIB 2 SURGE DOORS) (98D57004013000).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼2(86)
