(4)
 Clean the groove between the leading edge panel (2) and the outboard flap with CLEANING AGENTS (Material No. 11-026).

 (5)
 Seal the groove between the leading edge panel (2) and the outboard flap with SEALANTS (Material No. 09-016).

R **ON A/C 057-099, 101-149, 151-199, 201-299, 401-499,
 Subtask 27-54-62-420-066-A
 B. Installation of the Leading Edge Panels 2 and 5 on the Outboard Flap NOTE : The leading edge panel 2 is attached to the outboard flap with
____ rivets. Install the leading edge panel 2 on the outboard flap (Ref. CMM 575321).
 (1)
 Apply a layer of SEALANTS (Material No. 09-016) to the interface of the leading edge panel 5 (2) and the outboard flap.

 (2)
 Apply a layer of COMMON GREASE (Material No. 04-012) to the contact areas of the leading edge panel 5 (2).

 (3)
 Install the leading edge panel 5 (2) with the screws (1).

 (4)
 Clean the groove between the leading edge panel 5 (2) and the outboard flap with CLEANING AGENTS (Material No. 11-026).

 (5)
 Seal the groove between the leading edge panel 5 (2) and the outboard flap with SEALANTS (Material No. 09-016).

 **ON A/C ALL
 5. Close-up
________
 Subtask 27-54-62-865-058

 A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
 Subtask 27-54-62-860-062
 B. Aircraft Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
 (1) Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever.

 (2) Retract the flaps fully (Ref. TASK 27-50-00-866-009). Subtask 27-54-62-942-054
 C. Removal of Equipment
 (1)
 Remove the safety barriers

 (2)
 Remove the warning notice(s).

 (3)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

R 1EFF : ALL 1 27-54-62Page 488 1 1 May 01/05 1 1 1CES 1 **ON A/C 301-399,

 TASK 27-54-62-000-005
 Removal of the Outboard Flap Tab
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific support structure No specific warning notice No specific access platform 3 m (9 ft. 10 in.) 98D27504115000 2 DISTANCE GAUGES
 1EFF : 301-399, 1 27-54-62Page 489 1 1 May 01/05R 1 1 1CES 1

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-009 Retraction of the Flaps on the Ground 27-54-41-000-001 Removal of the Right Angle Gearbox 6203CM,(6253CM) 27-54-62-000-002 Removal of the Outboard Double-Slotted Flap 57-55-11-000-005 Removal of the Inboard and Outboard Flap Tab
 Hinge-Fairings 57-55-11-010-002 To Lower the Flap Track No. 3 & No. 4 Movable
 Fairings for Access 27-54-62-991-036 Fig. 424 27-54-62-991-037 Fig. 425 27-54-62-991-035 Fig. 426
 3. Job Set-up
__________
 Subtask 27-54-62-941-059
 A. Safety Precautions
 (1)
 Put the safety barriers in position.

 (2)
 Put a warning notice on panel 400VU to tell persons not to operate the landing gear.

 (3)
 Put a warning notice on panel 114VU to tell persons not to operate the flight controls.

 Subtask 27-54-62-860-058
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱6(80)