R R R R R R R R R R R R R R R -------------------------------------------------------------------------------| FIG. | ORIGINAL MANUFACTURING LIMITS | IN-SERVICE WEAR LIMITS | | DETAIL |---------------------------------------|----------------------------| | AND | DIMENSION | ASSEMBLY CLEARANCE| DIMENSION LIMITS | MAX. | | ITEM | MM (IN.) | MM (IN.) | MM (IN.) | ALLOW. | | NO. |-------------------|-------------------|---------|---------| CLEAR. | | | MIN. | MAX. | MIN. | MAX. | MIN. | MAX. |MM (IN.)| |--------|---------|---------|---------|---------|---------|---------|--------| | B | 30.950 | 30.975 | | | 30.900 | | | | OD 5 |(1.2185) |(1.2194) | | |(1.2165) | | | | | | | 0.025 | 0.075 | | | 0.175 | | | | | (0.0009)| (0.0029)| | |(0.0068)| | B | 31.000 | 31.025 | | | | 31.075 | | | ID 7 |(1.2204) |(1.2214) | | | |(1.2234) | | -------------------------------------------------------------------------------
R **ON A/C ALL
5. Close-up________
Subtask 27-54-61-410-055
A. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
(2) Connect the joints at tracks 1 and 2 to connect the actuator levers to the drive struts (Ref. TASK 27-54-55-400-001)
Subtask 27-54-61-942-059
B. Removal of Equipment
(1) Remove the safety barriers.
(2) Remove the warning notice(s).
(3) Remove the access platform(s).
(4) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
OUTBOARD FLAP - REMOVAL/INSTALLATION
____________________________________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
TASK 27-54-62-000-001
Removal of the Outboard Flap
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific adhesive tape
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱6(57)
