R 98D27309001000 1 TOOL-ELEVATOR NEUTRAL SETTING R 98D27903500000 2 PIN-SIDE STICK LOCKING
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
23-61-41-000-001 Removal of the Static Discharger 27-34-41-000-001 Removal of the Elevator 29-10-00-864-001 Depressurize the Green Hydraulic System 29-10-00-864-002 Depressurize the Yellow Hydraulic System 29-10-00-864-003 Depressurize the Blue Hydraulic System 55-14-11-000-001 Removal of the Tips 332AB/342AB 55-24-11-991-001 Fig. 401
3. Job Set-up
__________
Subtask 55-24-11-860-050
A. Depressurize Hydraulic Systems
(1) Depressurize the Green, Yellow and Blue hydraulic systems (Ref. TASK 29-10-00-864-001), (Ref. TASK 29-10-00-864-002) (Ref. TASK 29-10-00-864-003)
Subtask 55-24-11-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/ELAC1/NORM/SPLY 15CE1 B11 49VU FLIGHT CONTROLS/THS/ACTR/MOT2 19CE2 B09 105VU FLIGHT CONTROLS/ELAC2/STBY SPLY 16CE2 A02 105VU FLT CTL/ELAC1/STBY SPLY 16CE1 A01 121VU FLIGHT CONTROLS/THS ACTR/MOT3 19CE3 Q17 121VU FLIGHT CONTROLS/THS ACTR/MOT1 19CE1 Q16 121VU FLIGHT CONTROLS/ELAC2/NORM/SPLY 15CE2 R20
1EFF : ALL 1 55-24-11Page 402 1 1 Nov 01/02R 1 1 1CES 1
Subtask 55-24-11-481-050
C. Install Locking Devices R (1) Put the PIN-SIDE STICK LOCKING (98D27903500000) in the CAPT and F/O side stick controllers. R (2) Install the TOOL-ELEVATOR NEUTRAL SETTING (98D27309001000) on the
R elevator. Subtask 55-24-11-941-050
D. Safety Precautions
(1)
Put the warning notices in the flight compartment to tell persons not to operate the flight controls.
(2)
Put the warning notices in position to tell persons not to operate the hydraulic systems.
(3)
Put the access platform in position at zone 335 for the left hand elevator and/or zone 345 for the right hand elevator.
4. Procedure
_________
(Ref. Fig. 401/TASK 55-24-11-991-001)
Subtask 55-24-11-020-050
A. Removal
(1)
Remove the Elevator Tips
(a)
If you replace the elevator tips (2) and to prevent injuries, remove the static dischargers (4) (Ref. TASK 23-61-41-000-001)
(b)
Remove the horizontal stabilizer tips 332AB and 342AB as necessary (Ref. TASK 55-14-11-000-001)
(c)
Remove the screws (1).
(d)
Carefully remove the elevator tips (2).
(2)
Remove the Elevator End Caps
(a)
Remove the applicable elevator (Ref. TASK 27-34-41-000-001).
(b)
Remove the screws (1).
(c)
Carefully remove the elevator end caps (3).
Elevator Tips and Inboard End Caps
Figure 401/TASK 55-24-11-991-001
1EFF : ALL 1 55-24-11 Page 404
1 1 Feb 01/98
1 1
1CES 1
TASK 55-24-11-560-001
Preparation for Installation
WARNING : DO NOT GET THE COMPOUND ON YOUR SKIN.
_______ IF YOU DO:
-RUB IT OFF IMMEDIATELY WITH A CLEAN CLOTH
-WASH THE SKIN WITH SOAP AND RINSE WITH CLEAN WATER. WARNING : IF YOU GET THE FLUID ON YOUR SKIN OR IN YOUR EYES:
_______
-FLUSH IT AWAY WITH CLEAN WATER
-GET MEDICAL AID. WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE CLEAR.
_______ MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
WARNING : WEAR AND ATTACH A SAFETY HARNESS WHEN YOU WORK ON HIGH SECTIONS. A
_______ FALL CAN INJURE OR KILL YOU.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
CAUTION : DO NOT CAUSE DAMAGE TO THE SURFACES. THE COMPONENTS ARE MADE OF
_______ CARBONFIBER REINFORCED PLASTIC.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM STABILIZERS 安定面(65)
