(l)
Adjust the E2A and E2B cables if the tensions are more than +/-15 pounds from the specified value in graph II, Fig. 502.
(m)
Remove the rig pins E-1 and E-2.
(n)
Install the locking clips on all body cable turnbuckles.
(o)
Apply the corrosion preventive compound to the threads of the turnbuckles that show.
S 035-120
(8)
Reconnect the control rods (3 locations) between the autopilot servo modules and the aft quadrant.
S 865-105
(9)
Set the STAB TRIM 2 and 3 switches on the control stand to ON.
S 865-106
(10)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:
(a)
P180 DC Power Distribution Panel
1) 180E7 ELEV/RUD VLV SYS 2
2) 180E22 ELEV/RUD VLV SYS 4
3) 180H8 ELEV/RUD VLV SYS 1
4) 180H23 ELEV/RUD VLV SYS 3
S 865-107
(11)
Set all the FLT CONTROL HYD POWER TAIL switches on the P461 Pilots' Overhead Maintenance Panel to NORM.
I.
Adjust the Inboard Elevator
S 865-030
WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. AILERONS, RUDDERS, ELEVATORS, FLAPS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
(1)
Do this task to pressurize the hydraulic systems No. 2 and No. 3: "Supply Hydraulic Power" (Ref 29-11-00/201).
S 865-031
(2)
Use the STAB TRIM ALTN switches on the control stand to set the stabilizer to the rig neutral position (Ref 27-41-00/201).
(a)
Make sure the stabilizer trim position indicators on the P8 control stand shows 3.00 units of trim.
(b)
Make sure the B dimension on the stabilizer jackscrew is
7.42 +/- 0.05 inches.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-00
ALL ú ú 01 Page 513 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
INBD END OF THE INBD ELEV
TRAILING EDGE IN LINE WITH 1 |.2 DEGREES
STABILIZER CENTERLINE ON THE INDEX PLATE UP ELEV (INBD
RIG PIN INSTALLED)
Elevator Neutral Adjustment and Neutral Test Figure 503 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-00
ALL ú ú 01 Page 514 ú Feb 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
Elevator Neutral Adjustment and Neutral Test
Figure 503 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-00
ALL ú ú 01 Page 515 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
E2B
E2A E1B
E1A
SEE A TURNBUCKLES (4 LOCATIONS)
SEE B
INBOARD ELEVATOR POWER PACKAGE INPUT ROD
OUTBOARD ELEVATOR POWER PACKAGE INPUT ROD
RIG PIN E-2
1.22 INCHES MAX
1.78 INCHES MAX SEE C
LEFT SIDE SHOWN RIGHT SIDE OPPOSITE
A
CHECKNUT 1.29 INCHES MAX CLEVIS
SLEEVE 1.29 INCHES MAX
CHECKNUT
B
CHECKNUT INPUT
SLEEVE
CONTROL UP
CHECKNUT
ROD C Elevator Power Package Input Rod and Slave Control Cable Adjustment Figure 504
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-00
ALL ú ú 01 Page 516 ú Jun 10/90
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(20)
