27-41-07
ALL ú ú 01 Page 507 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
2) Measure the control column angle at this position. 3) Make sure the difference between the control column angles at the neutral and forward position is 3.7-5.5 degrees.
(e) Move the control column to neutral detent.
S 715-023
(9)
If you replaced the autopilot A or B limit switch, do the automatic stabilizer trim test (AMM 22-10-00/501).
S 865-024
(10)
If the hydraulic power is not necessary, do this task: "Remove Hydraulic Power" (AMM 29-11-00/201).
S 865-025
(11)
If the electrical power is not necessary, do this task: "Remove Electrical Power" (AMM 24-22-00/201).
(12)
Close the ceiling panel.
S 415-026
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-41-07
ALL ú ú 01 Page 508 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
STABILIZER TRIM LIMIT SWITCHES - REMOVAL/INSTALLATION
_____________________________________________________
1. General_______
A. There are four tasks in this procedure. There is one task each for the removal and the installation of the stabilizer trim limit switches (which is referred to as the "limit switches") and the fuel range limit switch (which is referred to as the "fuel switch"). The procedure has these parts:
(1)
The removal of the limit switch and the mounting bracket (which is referred to as the "switch assembly")
(2)
The removal of the limit switch from the mounting bracket
(3)
The installation of the replacement switch assembly
(4)
The removal of the fuel switch
(5)
The installation of the fuel switch.
B.
The limit switches are on the mounting brackets that are attached to the bulkhead forward of the stabilizer front spar. Each switch and mounting bracket is removed as a unit (switch assembly). The mounting bracket and switch are assembled and adjusted as a unit before the installation.
C.
The removal and installation procedure is the same for all limit
switches.
D.
The fuel switch is on the left bulkhead forward of the stabilizer front spar.
TASK 27-41-08-004-001
2. Stabilizer Trim Limit Switch Removal (Fig. 401)____________________________________
A. Standard Tools and Equipment
(1)
Ohmmeter
B.
References
(1)
AMM 06-09-05/201, Body Section 48 Access Doors and Panels
(2)
AIPC 27-41-04, Fig. 3
(3)
WDM 27-41-11, WDM 27-41-21
C.
Access
(1)
Location Zone
311 Area Aft of Pressure Bulkhead, LH
312 Area Aft of Pressure Bulkhead, RH
(2)
Access Panel 312A Horizontal Stabilizer Jackscrew Access Door
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-41-08
ALL ú ú 12 Page 401 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
SEE A
SEE B SEE A
ALTERNATE ELECTRIC
0.25 UNITS SEE EALTERNATE ELECTRIC
14.75 UNITS
ALTERNATE ELECTRIC
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(186)
