28-41-00
FUEL QUANTITY INDICATORS ú ú 01A Page 8 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH ANALOG ú
28-41-00
FUEL QUANTITY INDICATORS ú ú 01A Page 9 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
SCREWDRIVER SLOT
NOTE: SOME PARTS ARE NOT SHOWN TO MAKE THE ILLUSTRATION EASIER TO READ.
Fuel Measuring Stick Extended Position (Example) Figure 3
A09878
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH ANALOG ú
28-41-00
FUEL QUANTITY INDICATORS ú ú 01A Page 10 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
FUEL QUANTITY INDICATING SYSTEM - TROUBLE SHOOTING
__________________________________________________
1. General_______
A. These trouble shooting procedures were developed from data from a standard system operational test. The procedures are in a tree-type configuration. The steps related to the refuel operation (heavy-line boxes) are connected by arrows to show the path through the tests that gives good (system operable) results (OK condition).
B. When a step in an operational test does not give a good result, follow the NOT OK line to the box that contains the applicable problem. Refer to the procedure shown in that box. Continue to analyze the results of each step in trouble shooting until you find the applicable solution to the problem. Do the steps necessary to correct the problem. Then do the step where you first found the problem again to make sure you corrected the problem.
C. Try these easier procedures to find problems with the fuel quantity indicating sytem before you do the longer trouble shooting procedure:
NOTE: This will keep the time necessary to do the trouble shooting
____ to a minimum. Use the longer trouble shooting procedure only if these steps do not find the problem.
(1)
Replace the applicable indicator in the flight compartment with the refuel indicator (the indicator on the P15 panel on the wing) for that same tank. Replace the refuel indicator with the indicator for that same tank from the flight compartment.
NOTE:____These two indicators have the same part number. They do not usually become bad at the same time.
(2)
Make sure the task "Fuel System Drainage" (Sumping) was done a short time before (a minimum of 45 minutes after the airplane movement stops rest or after the refuel operation is completed). This procedure is necessary to drain water collected in the tank. If the conditions of operation are very bad it is recommended that 5 gallons (19 liters) be drained from each tank for each 24 hours. (For example, this is a good procedure if the weather is very hot and humid.)
(3)
Examine the bussing plug seals on the wing spar for indications of leakage of fuel or water. This can cause electrical leakage paths between the connector pins. If you think the bussing plug has a problem, replace the bussing plug with a good bussing plug. This procedure will make sure that the bussing plug was the cause of the problem.
(4)
Do the press-to-test operation of the fuel quantity indicators, with the QTY TEST switch in the flight compartment. If none of the indicators operate correctly, there is a problem with the power supply for the indicators. If only one indicator does not operate correctly (the other indicators do operate correctly), the problem is usually in the bad indicator.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燃油 FUEL 3(36)
