28-41-21
 ALL  ú ú 04 Page 509 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 TANK AND COMPENSATOR UNITS - CLEANING/PAINTING
______________________________________________
 1.  General_______
 A.  This procedure has one task, to clean the tank units and the compensator unit. The procedure removes microbial contamination from these units.
 TASK 28-41-21-117-001
 2.  Clean the Tank Unit or the Compensator Unit___________________________________________
 A.  Standard Tools and Equipment
 (1)  
Container - with sufficient depth to clean tank units

 (2)  
Brushes - Nylon bristle

 (3)  
Brush - with a bristle outside diameter of 1/4 to 3/8 inch. An extension rod must be attached and the handle and the extension must have a plastic cover.

 B.  Consumable Materials
 (1)  B00065 - Alcohol, O-A-396
 C.  References
 (1)  28-41-21/401, Tank and Compensator Units
 D.  Access
 (1)  Location Zone
 221 Center Section Fuel Tank
 305 Left Fuel Tank
 405 Right Fuel Tank

 E.  Procedure
 S 017-002
 (1)  Remove the applicable tank unit or the compensator
 (AMM 28-41-21/401).

 S 117-007
 WARNING:_______MAKE SURE THE AREA HAS A GOOD FLOW OF AIR. DO NOT BREATHE THE GAS FROM THE ALCOHOL OR USE IT IN AN AREA WITH AN OPEN FLAME. INJURY TO PERSONS CAN EASILY OCCUR.
 CAUTION: DO NOT MOVE OR LOOSEN THE SPACERS WHEN YOU CLEAN THE INNER
_______ ELECTRODE. THE FUEL QUANTITY INDICATING SYSTEM WILL NOT GIVE THE CORRECT VALUE.
 (2)  Fully rub all of the surfaces of the tank unit or the compensator with the alcohol and the nylon brushes.
 (a)  Do not use water or soap.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-41-21
 ALL  ú ú 01 Page 701 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (b) (c)  Do not make scratches in the tank unit or the compensator.Make sure you remove all of the microbial contamination.
 (3)  S 177-004Remove all of the loose material with a good flow of clean alcohol.
 (4)  S 167-005Fully rub the tank unit or the compensator with a clean lintfree cloth to dry it.
 (5)  S 417-006Install the tank unit or the compensator (Ref 28-41-21/401).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-41-21
 ALL  ú ú 01 Page 702 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 FUEL QUANTITY INDICATING SYSTEM WIRE HARNESS - APPROVED REPAIRS
_______________________________________________________________
 1.  General_______
 A.  This procedure is to be used only for the recrimping of FQIS wire harnesses with terminal lugs that were originally crimped and not soldered. This procedure is not to be used for the repair of FQIS wire harnesses with terminal lugs that are crimped and soldered.
 B.  This procedure has one task. The task is to tighten the crimp on the terminal lugs for the wire harness in the fuel tank.
 C.  It can be necessary to tighten the crimp in the terminal lugs to make a better connection to the wire bundle. This makes sure that there is electrical continuity in the fuel quantity indicating system.
 TASK 28-41-31-358-001
 2.  Recrimp Fuel Tank Wire Harness Terminal Lug___________________________________________
 A.  Special Tools and Equipment
 (1)
59250 - Tool, AMP hand-crimping, (alternative to 59170)

 (2)
59170 - Tool, AMP hand crimping, (alternative to 59250)

 B.  References
 (1)
AMM 28-10-00/201, Storage

 (2)
AMM 28-11-11/401, Wing Fuel Tank Access Panels

 (3)
AMM 28-11-31/401, Center Tank Access Panel

 (4)
AMM 28-23-00/201, Defueling
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燃油 FUEL 3(117)