曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 ú  column should move slowly forward.
 8) Set the stabilizer to 5 units of trim, if necessary.
 (b) Set the autopilot cutout switch to CUTOUT.
 1) The autopilot will disengage.
 2) Move the control column a minimum of two inches forward
 then a minimum of two inches aft.
 3) Make sure the system does not operate.
 (c) Set the autopilot cutout switch to NORMAL.
 1) Engage the autopilot.
 2) Move the control column a minimum of two inches forward and
 then a minimum of two inches aft.
 3) Make sure the stabilizer moves in the correct direction.
 (d) Disengage the autopilot.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-91
 ALL  ú ú 01.1 Page 502 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-004
 (6)  If the electrical power is not necessary, do this task: "Remove Electrical Power" (AMM 24-22-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 ú

 27-41-91
 ú ALL ú ú ú 01.101 Page 503 ú ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 STABILIZER TRIM LIMIT SWITCHES - REMOVAL/INSTALLATION
_____________________________________________________
 1.  General_______
 A.  This procedure has two tasks, one for the removal and one for the installation of the stabilizer trim limit switch (which is referred to as the "limit switch"). The procedure has these parts:
 (1)  
The removal of the limit switch

 (2)  
The installation of the limit switch.

 B.  
There are four limit switches S115, S144, S145 and S844 and two stabilizer takeoff warning switches on the brackets along the stabilizer jackscrew. Refer to AMM 31-26-24/401 for the removal and installation procedures of the stabilizer takeoff warning switches (S132 and S546).

 C.  
The limit switches stop the travel of the horizontal stabilizer at the limits. The limit switches operate to stop the stabilizer travel by a cam on the jackscrew attach fitting of the stabilizer center section.

 TASK 27-41-94-004-008
 2.  Stabilizer Trim Limit Switches Removal (Fig. 401)______________________________________
 A.  References
 (1)  
AMM 12-31-41/201, Body Section 48 Access Doors and Panels

 B.  
Access

 (1)  
Location Zone
 701 Tail Compartment

 (2)  
Access Panels
 3701 Stabilizer Trim Access Door

 C.  
Procedure

 S 014-002
 (1)  
Open the access door 3701 (AMM 12-31-41/201).

 S 864-003

 (2)  
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 (a)  
P6-2 Circuit Breaker Panel
 1) STABILIZER TRIM CONT
 2) If it is necessary:

 

 AURAL WARN
 S 024-001
 (3)  
Remove the limit switch:

 (a)  
Disconnect the switch wires at the wire connection.

 (b)  
Remove the switch arm: 1) Remove the switch arm nut. 2) Pull the switch arm from the switch shaft.

 (c)  
Remove the limit switch: 1) Hold the limit switch while you remove the switch nut.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-94
 ALL  ú ú 01 Page 401 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

737-300/400/500
MAINTENANCE MANUAL

STABILIZER DOWN
STABILIZER UP
STAB TRIM 
LIMIT SWITCHES 
(AIRPLANE NOSE DOWN) 
SEE  B 
SEE  A 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(121)