C HINGE TRACE
LC-C
D-D
Rudder Installation
Figure 401 (Sheet 5)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
AIRPLANES WITH GRAPHITE/COMPOSITE RUDDER ú 27-21-11
ú ú 04 Page 406 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
E82958
A 737-300/400/500MAINTENANCE MANUAL
RUDDER SLING ASSEMBLY
Rudder Removal/Installation Sling
Figure 402
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
AIRPLANES WITH GRAPHITE/COMPOSITE RUDDER ú 27-21-11
ú ú 01 Page 407 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(c) The seals and the seal attachment plates from each side of the fin at the rudder balance weight.
S 494-005
(3)
Install the rudder sling:
(a)
Remove the seal segments from the trailing edge of the vertical fin near hinges 4 and 5.
(b)
Remove the bearing bars from hinges 4 and 5.
(c)
Remove the hinge segments for hinges 4 and 5 from the vertical fin.
(d)
Connect the rudder sling to the rudder at hinges 4 and 5.
(e)
Assemble the rudder sling as shown (Fig. 402).
(f)
Connect the crane to the rudder sling.
S 494-050
(4)
Attach ropes to the rudder to pull the rudder away from the airplane when you remove it.
F.
Remove the Rudder (Fig. 401)
S 034-006
(1)
Disconnect these components from the rudder:
(a)
The power control unit (PCU)
(b)
The standby actuator
(c)
The bonding jumper you find approximately 5.5 inch below hinge 7
(d)
The bonding jumper from hinge 3.
S 034-007
(2)
AIRPLANES WITH A RUDDER POSITION TRANSMITTER; Disconnect the aft end of the transmitter control rod from the rudder.
S 034-009
(3)
Remove the hinge bolts from hinges 2, 3, and 6.
(a)
Remove the bolts, shims, and washers that connect the bearing bar for hinge 2 to the rudder.
S 034-010
WARNING: MAKE SURE THE CRANE WILL HOLD THE RUDDER IN A STABLE POSITION
_______ WHEN YOU REMOVE THE HINGE BOLTS. ACCIDENTAL RUDDER MOVEMENT WHEN YOU DISCONNECT IT FROM THE AIRPLANE CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(4) Remove the hinge bolts from hinges 1 and 7.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
AIRPLANES WITH GRAPHITE/COMPOSITE RUDDER ú 27-21-11
ú ú 03 Page 408 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 864-011
(5) Use the ropes to pull the rudder away from the airplane while you lower it to the ground.
NOTE: The rudder weight is approximately 160 pounds.
____
TASK 27-21-11-424-012
3. Rudder Installation___________________
A. Special Tools and Equipment
(1)
Sling, Rudder - C27003
B.
Standard Tools and Equipment
(1)
Crane
(2)
Block, Wood - Approximately 3 inches by 3 inches by 0.25 inch thick, with a pad to prevent damage to the rudder skin.
(3)
Spring Scale, 0-50 pound capacity
(4)
Milliohmmeter - 0 to 0.1 ohm range.
C.
Consumable Materials
(1)
D00015 Compound, Corrosion Preventive - BMS 3-24
(2) 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(29)
