27-31-00
 ALL  ú ú 01 Page 552 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 4) Hold the control column full forward. a) Move the control wheel between the left and right stops. 5) Hold the control column full aft. a) Move the control wheel between the left and right stops. 6) Attach the bubble protractor to the captain's control column.
 7)  Move the control column aft until the column stops are contacted and hold. a) Make sure the trailing edge of the right elevator moves
 14.60 +0.30/-0.85 inches up from the index mark. b) Make sure the position of the captain's control column is aft of the vertical 7 degrees minimum (Fig. 501). c) Release the control column.
 8)  Move the control column forward until the stops are contacted and hold. a) Make sure the trailing edge of the right elevator moves
 10.55 |0.60/-0.60 inches down from the index mark. b) Make sure the position of the captain's control column is forward of the vertical 19.8 degrees minimum. c) Release the control column.
 9)  Make sure the total travel of the captain's column is 28.4 degrees minimum.
 (b)  
Move the captain's control column slowly aft until the elevator is at 3.90 |0.05 inches up from the neutral position. 1) Hold the control column at this position. 2) Make sure the column force is not more than 42.5 pounds.

 (c)  
Move the captain's control column slowly forward until the elevator is at 3.90 |0.5 inches down from the neutral position. 1) Hold the control column at this position. 2) Make sure the column force is not more than 54.5 pounds.

 (d)  
Remove the bubble protractor from the captain's control column.

 S 865-060
 (5)  
Do this task: "Put the Elevator Hydraulic Systems A and B Back to the Condition Before the Pressurization" (AMM 27-31-00/201).

 (6)  
Do the test of the power mode operation in paragraph 12.

 S 735-061
 TASK 27-31-00-735-024
 12. System Test - Power Mode Operation
__________________________________
 A.  Special Tools and Equipment
 (1)  
F80055-1 - Trammel Bar

 (2)  
F72867-1 - Control Wheel Adapter Fitting

 (3)  
4MIT65B80307-1 - Bubble Protractor

 (4)  
F52485-5 - Bubble Protractor

 B.  
Standard Tools and Equipment

 (1)  
Spring Scale - 0-50 pound push-pull scale with the scale graduations of 0.5 pounds or smaller

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-00
 ALL  ú ú 01 Page 553 ú Mar 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 C.
D.
E.
A
737-300/400/500MAINTENANCE MANUAL
 (2)
Scale - 0-2 feetReferences

 (1)
AMM 27-31-00/201, Elevator and Tab Control SystemAccess

 (1)  
Location Zones 101 Control Cabin, LH 102 Control Cabin, RH 711 Elevator and Tab, LH 712 Elevator and Tab, RH

Procedure
 S 865-025
 (1)  
Use the trammel bar to set the B dimension at 41.57 |0.05 inches.

 S 865-026

 (2)  
Do this task: "Null Procedure - Mach Trim Actuator" (Ref 27-31-00/201).

 S 865-027

 (3)  
Supply the elevator hydraulic systems A and B (AMM 27-31-00/201).

 S 735-095

 (4)  
Do a test of the power mode operation:

 (a)  
Move the captain's column lightly in a longitudinal direction to make sure the system is in the center position and release.

 (b)  
Attach the bubble protractor to the captain's column.

 (c)  
Make sure the captain's column position is 6.9 |0.8 degrees forward of the vertical.

 (d)  
Move the captain's column slowly between the forward and aft stops. 1) Make sure the column moves freely and there is no unwanted

 noise in the system.

 (e)  
Attach the bubble protractor to the first officer's column.

 (f)  
Make sure the position of the first officer is 6.9 |0.8 degrees forward of the vertical.

 (g)  
Move the first officer's column slowly between the forward and aft stops. 1) Make sure the column moves freely and there is no unwanted
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(123)