曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 ú ú ú ú NOTE:____ If you install the same elevator that you removed,and no other adjustments to the elevator system have beenmade, then it is not necessary to adjust the elevator system.
 ú  (a)  While you move the elevator trailing edge down, align the projected center of the elevator trailing edge with the indexmark within +/- 0.04 inch or less.
 NOTE:____ Keep the elevators at this position while you do the step to measure the elevator tab position. If the elevator position is changed, you must put the elevator trailing edge at the full up position and do this step again before you continue.
 (b) (c)  Adjust the elevator tab to the same position recorded when the tab was removed. Use the single point method in the adjustment (AMM 27-31-00/501).If the elevator tab rods are aluminum and the ambient temperature has changed from the ambient temperature recorded in the removal, then rig position must be adjusted for the temperature difference. The tab rig position should be increased by 0.0073 inch for each 10 degree fahrenheit increase in temperature or decreased by 0.0073 inch for each 10 degree fahrenheit decrease in temperature.
 A temperature adjustment is not needed for titanium rods.
 NOTE:____ For example- elevator tab position "a" is measured and recorded as 0.332 inch at ambient temperature of 40 degrees fahrenheit. At the time the tab is to be rigged the ambient temperature is 70 degrees fahrenheit. With the temperature adjustment the tab control rods are rigged to a tab position of 0.310 inch (0.332 + (-0.0219)).
 S 714-015
 (13) Do this task: "Operational Test - Elevator and Tab Control System" (Ref 27-31-00/501).
 S 414-016
 (14) Close or replace all access doors and panels.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-11
 ALL  ú ú 03.1 Page 417 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 ú
 ú  S 714-017
 ú  (15) If it is necessary, do this task:  "Elevator Power Off Flight Test"
 ú  (AMM 27-31-00/501).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-11
 ALL  ú ú 04.1 Page 418 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 ELEVATOR - INSPECTION/CHECK
___________________________
 1.  General_______
 A.  This procedure has one task. The task is an inspection of the elevator hinges. The procedure has these parts:
 (1)  
The removal of the elevators

 (2)  
An inspection of the elevator hinges

 (3)  
An inspection of the elevator control linkage

 (4)  
The installation of the elevators.

 TASK 27-31-11-206-001
 2.  Elevator Wear Limits Inspection (Fig. 601 and 602)_______________________________
 A.  General
 (1)  This task contains the wear limits inspections of the elevator hinges and the elevator control linkage.

Elevator Hinge Wear Limits
Figure 601 (Sheet 1)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-11
 ALL  ú ú 01 Page 601 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
1. BEARING/BOLT
 (HEAD OUTBOARD, OR INBOARD NO. 6 ONLY)
2. BUSHING/BOLT
A
3. BEARING/BOLT
4. BUSHING/BOLT
B
Elevator Hinge Wear Limits
Figure 601 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-11
 ALL  ú ú 01 Page 602 ú Jun 25/85
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(141)