A. Removal of the Kicker Plate from the Blocker Door
 (1) Manually move the blocker door to the open position (Ref. TASK 78-32-41-860-001).

 (2) Install the SAFETY SLEEVE - PIVOTING DOOR ACTUATOR (HIX3005) on the blocker door (Ref. TASK 78-32-41-480-001).

 (3) Remove the nuts (10), (40), the washers (20), (50), and the screws (30), (60) which attach the kicker plates to the blocker door.

 (4) Discard the nuts (10) and (40).

 (5) Remove the kicker plates from the blocker door.

 F 『 EEFF : ALL E Page 43678-32-41
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 INTENTIONALLY BLANK

 F 『 E E Page 43778-32-41
 E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E

 Blocker Door Kicker Plates
 Figure 408/TASK 78-32-41-991-316- 12 (SHEET 1)
 F EEFF :  ALL  『E 78-32-41 Page 438 
E  E  Feb 01/98
 E  E
 ECES  E

 Blocker Door Kicker Plates
 Figure 408/TASK 78-32-41-991-316- 22 (SHEET 2)
 F EEFF :  ALL  『E 78-32-41 Page 439 
E  E  Feb 01/98
 E  E
 ECES  E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

 TASK 78-32-41-400-004
 Installation of the Kicker Plate from the Blocker Door
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific warning notice
 No specific access platform 1 m (3 ft. 3 in.)
 HIX3005 1 SAFETY SLEEVE - PIVOTING DOOR ACTUATOR

 B. Expendable Parts
 -------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
 -------------------------------------------------------------------------------
R 10 Nuts 78-32-41 01A-280 R 40 Nuts 78-32-41 01A-280 R
 C. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors
 71-13-00-410-040 Closing of the Fan Cowl Doors
 78-30-00-081-041 Make the Thrust Reverser Serviceable after

 Maintenance
 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance
 78-32-41-080-001 Removal of the Safety Sleeve from Blocker Door

 Actuator
 78-32-41-820-001 Alignment of the Blocker Door
 78-32-41-860-002 Manual Stowing of the Blocker Door
 78-32-41-991-316 Fig. 408

 F 『 EEFF : ALL E Page 44078-32-41
 E E Aug 01/04 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

 3. Job Set-up
__________
 Subtask 78-32-41-860-056
 A. Aircraft Maintenance Configuration
 (1) On the center pedestal, on the ENG panel 115VU, make sure that a warning notice is in position to tell persons not to start the engine.

 (2) On the overhead maintenance panel 50VU, make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off. Make sure that a warning notice is in position to tell persons not to energize the FADEC 1(2).

 (3) Make sure that the access platform is in position.

 Subtask 78-32-41-010-066
 B. Make sure that the fan cowl doors are open (Ref. TASK 71-13-00-010-040): FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR
 Subtask 78-32-41-040-065
 C. Make sure that the thrust reverser is unserviceable (Ref. TASK 78-30-00-481-041).
 4. Procedure
_________
 (Ref. Fig. 408/TASK 78-32-41-991-316)
 Subtask 78-32-41-420-053
 A. Installation of the Kicker Plate on the Blocker Door
 CAUTION : DO NOT PUSH ON THE STOW SWITCH LEVER WHEN BLOCKER DOOR IS
_______
 OPENED OR DAMAGE COULD OCCUR.

 (1) Install the Kicker Plate on the Blocker Door.
R (2) Install the screws (30), (60), the washers (20), (50) and new Nuts R (10) and Nuts (40).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(72)