F 『
E C F M E
E E
E 56-5B E
E E
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-80-00-866-005 71-13-00-010-040 71-13-00-410-040 78-30-00-081-041
78-30-00-481-041
78-32-11-000-001 78-32-11-000-002
78-32-11-400-001
78-32-11-400-002
78-32-41-080-001
78-32-41-480-001
78-32-41-860-001 78-32-41-860-002 78-36-00-010-040 78-36-00-410-040 SPM 70-62-12 SRM 54-30-00 78-32-11-991-309 78-32-11-991-310
3. Job Set-up
__________
Subtask 78-32-11-941-053
A. Safety PrecautionsRetracting the Slats on the GroundOpening of the Fan Cowl DoorsClosing of the Fan Cowl DoorsMake the Thrust Reverser Serviceable after MaintenanceMake the Thrust Reverser Unserviceable for MaintenanceRemoval of the One or Eleven O'clock Strut BushingRemoval of the Left or Right Half Door of Thrust ReverserInstallation of the One or Eleven O'clock Strut BushingInstallation of the Left or Right Half Door of Thrust ReverserRemoval of the Safety Sleeve from Blocker Door ActuatorInstallation of the Safety Sleeve on Blocker Door ActuatorManual Deployment of the Blocker DoorManual Stowing of the Blocker DoorOpening of the Thrust Reverser DoorsClosing of the Thrust Reverser Doors
Fig. 601Fig. 602
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
F 『 EEFF : ALL E Page 60278-32-11
E E Feb 01/98 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 78-32-11-869-051
B. Retract the slats (Ref. TASK 27-80-00-866-005) and install a warning notice.
Subtask 78-32-11-010-051
C. Get Access
(1) Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2) Put an access platform in position. Subtask 78-32-11-040-051
D. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). NOTE : Do not close the fan cowl doors.
____
4. Procedure
_________ (Ref. Fig. 601/TASK 78-32-11-991-309, 602/TASK 78-32-11-991-310) Subtask 78-32-11-210-050
A. Visual Inspection NOTE : Apply a witness line of finish paint EA4 blue 5991 (Material No.
____ CP2245) on all nuts and connections when you have done the check of their torques.
F 『 EEFF : ALL E Page 60378-32-11
E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E
Thrust Reverser
Figure 601/TASK 78-32-11-991-309- 12 (SHEET 1)
F EEFF : ALL 『E 78-32-11 Page 604
E E Feb 01/98
E E
ECES E
Thrust Reverser
Figure 601/TASK 78-32-11-991-309- 22 (SHEET 2)
F EEFF : ALL 『E 78-32-11 Page 605
E E Feb 01/98
E E
ECES E
Pivot Bolts
Figure 602/TASK 78-32-11-991-310
F 『 EEFF : ALL E Page 60678-32-11
E E Feb 01/98 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
(1) Do a visual inspection of the upper/lower cut corners, the 3/9 o'clock beams, the aft ring and the strut as follows:
-------------------------------------------------------------------------------INSPECT/CHECK MAXIMUM REMARKS SERVICEABLE LIMITS -------------------------------------------------------------------------------
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(55)
