R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,

 57-55-00-991-007  Fig. 403
 **ON A/C 301-399,
 57-55-00-991-007-A  Fig. 403A
 **ON A/C ALL
 3. Job Set-up__________
 Subtask 57-55-00-941-057
 A. Safety Precautions

 (1)
 Put warning notices in the cockpit to tell persons not to operate the flaps or slats.

 (2)
 Put the safety barriers in position.

 Subtask 57-55-00-860-055
 B. Aircraft Maintenance Configuration
 (1)
 Make sure that the flaps are fully retracted (Ref. TASK 27-50-00-866-009).

 (2)
 Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) on the flap/slat control lever.

 Subtask 57-55-00-865-064
 C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
 Subtask 57-55-00-010-052
 D. Get Access
 (1) Put the adjustable access platform below the applicable flap track 2, 3 or 4, zone 531(631), 532(632) or 533(633).
 4. Procedure
_________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 (Ref. Fig. 403/TASK 57-55-00-991-007)
 **ON A/C 301-399,

 (Ref. Fig. 403A/TASK 57-55-00-991-007-A)R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,

 Subtask 57-55-00-440-052
 A. Restoration of the Aircraft for Flight after Damage to the Flap-Track Fairing Seals
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 (1)
 Remove the applicable damaged fairing (Ref. TASK 57-55-11-000-001).

 (2)
 Remove and replace the damaged seal:

 -
for flap track 2, refer to the Component Maintenance Manual (Ref. CMM 57-55-12)

 -
for flap track 3, refer to the Component Maintenance Manual (Ref. CMM 57-55-13)

 -
for flap track 4, refer to the Component Maintenance Manual (Ref. CMM 57-55-14).

 (3)
 Install the applicable repaired fairing (Ref. TASK 57-55-11-400-001).

 (4)
 Make a note in the aircraft log that the seals have been replaced.

 **ON A/C 301-399,
 Subtask 57-55-00-440-052-A
 A. Restoration of the Aircraft for Flight after Damage to the Flap-Track Fairing Seals
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 (1) Remove the applicable damaged fairing (Ref. TASK 57-55-11-000-004).

R  (2) Remove and replace the damaged seal: 
R  - for flap track 2, refer to the Component Maintenance Manual (Ref. 
R  CMM 57-55-15) 
R  - for flap track 3, refer to the Component Maintenance Manual (Ref. 
R  CMM 57-55-16) 
R  - for flap track 4, refer to the Component Maintenance Manual (Ref. 
R  CMM 57-55-17). 
R  (3) Install the applicable repaired fairing (Ref. TASK 57-55-11-400-004). 
R  (4) Make a note in the aircraft log that the seals have been replaced. 
R  **ON A/C ALL 
R  5. Close-up________ 
R  Subtask 57-55-00-410-051 
R  A. Close Access 
R  (1) Remove the access platform(s). 
R  Subtask 57-55-00-865-065 
R  B. Make sure that this(these) circuit breaker(s) is(are) closed: 
R  6CV, 8CV. 
R  Subtask 57-55-00-942-055 
R  C. Removal of Equipment 
R  (1) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  (2) Remove the warning notice(s). 
R  (3) Remove the safety barriers. 
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM WINGS 機(jī)翼5(51)