C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 57-55-11-000-004 Removal of the Flap Track Fairings Nos. 2, 3 and 4 57-55-11-400-004 Installation of the Flap Track Fairings Nos. 2, 3 and
4 NTM 575339 PART 9 ASRM 575300 (for corrective action) 57-53-00-991-038 Fig. 634
3. Job Set-up
__________ Subtask 57-53-00-941-091
A. Safety Precautions
(1) Put a warning notice on the flap/slat control lever (panel 114VU) to tell persons not to operate the flaps.
(2) Put the safety barriers in position. Subtask 57-53-00-860-072
B. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(1)
Fully extend the flaps (Ref. TASK 27-50-00-866-008).
(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever on the panel 114VU.
R 1EFF : 301-399, 1 57-53-00Page B631 1 1 Nov 01/04 1 1 1CES 1
Subtask 57-53-00-865-129
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
Subtask 57-53-00-010-085
D. Get Access
(1)
Put the access platform in position below the flap track 3 at zone 587(687).
(2)
Remove the access cover 532AT (632AT) and the flap track 3 fairing 532CB (632CB) (Ref. TASK 57-55-11-000-004).
(3)
Put the spark-proof lamp adjacent to the inspection area.
4. Procedure
_________ (Ref. Fig. 634/TASK 57-53-00-991-038) Subtask 57-53-00-110-089
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the outboard double slotted flap tab articulation at track 3, LH/RH.
Subtask 57-53-00-280-065
B. Inspection
(1) Do a special detailed inspection of the tab articulation components and the internal surface of the tab at track 3, LH/RH . Refer to (Ref. NTM 575339 PART 9), for the inspection procedure.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 575300) for the
____ correct repair procedure. If the defect is not included in this repair, you must request a procedure from Airbus Industrie.
R 1EFF : 301-399, 1 57-53-00Page B632 1 1 Nov 01/04 1 1 1CES 1
Outboard Flap - Tab Articulation at Track 3 - Inspection Area Figure 634/TASK 57-53-00-991-038
1EFF : 301-399, 1 57-53-00Page B633 1 1 Nov 01/04R 1 1 1CES 1
5. Close-up
________
Subtask 57-53-00-410-084
A. Close Access
(1)
Remove the spark-proof lamp from the inspection area.
(2)
Install the flap track 3 fairing 532CB (632CB) and the access cover 532AT (632AT) (Ref. TASK 57-55-11-400-004).
(3)
Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 57-53-00-865-130
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼5(23)
