曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

and cleared by air traffic control.
(See FIG ENR 1.5−23.)
AIP ENR 1.5−33
United States of America 15 MAR 07
Federal Aviation Administration Nineteenth Edition
FIG ENR 1.5−24
Minimum Vectoring Altitude Charts
1500
2000
3000
3000
3000
3500
2500
5000
5500
5
10
15
20
25
30
348 013
057
102
160
250
277
289
N
12.5 Minimum Vectoring Altitudes (MVAs) are
established for use by ATC when radar ATC is
exercised. MVA charts are prepared by air traffic
facilities at locations where there are numerous
different minimum IFR altitudes. Each MVA chart
has sectors large enough to accommodate vectoring
of aircraft within the sector at the MVA. Each sector
boundary is at least 3 miles from the obstruction
determining the MVA. To avoid a large sector with an
excessively high MVA due to an isolated prominent
obstruction, the obstruction may be enclosed in a
buffer area whose boundaries are at least 3 miles from
the obstruction. This is done to facilitate vectoring
around the obstruction. (See FIG ENR 1.5−24.)
12.5.1 The minimum vectoring altitude in each
sector provides 1,000 feet above the highest obstacle
in nonmountainous areas and 2,000 feet above the
highest obstacle in designated mountainous areas.
Where lower MVAs are required in designated
mountainous areas to achieve compatibility with
terminal routes or to permit vectoring to an IAP,
1,000 feet of obstacle clearance may be authorized
with the use of Airport Surveillance Radar (ASR).
The minimum vectoring altitude will provide at least
300 feet above the floor of controlled airspace.
NOTE−
OROCA is an off−route altitude which provides
obstruction clearance with a 1,000 foot buffer in
nonmountainous terrain areas and a 2,000 foot buffer in
designated mountainous areas within the U.S. This altitude
may not provide signal coverage from ground−based
navigational aids, air traffic control radar, or
communications coverage.
12.5.2 Because of differences in the areas considered
for MVA, and those applied to other minimum
altitudes, and the ability to isolate specific obstacles,
some MVAs may be lower than the nonradar
Minimum En Route Altitudes (MEAs), Minimum
Obstruction Clearance Altitudes (MOCAs) or other
minimum altitudes depicted on charts for a given
location. While being radar vectored, IFR altitude
assignments by ATC will be at or above MVA.
12.6 Visual Descent Points (VDPs) are being
incorporated in nonprecision approach procedures.
The VDP is a defined point on the final approach
course of a nonprecision straight-in approach
procedure from which normal descent from the MDA
to the runway touchdown point may be commenced,
provided visual reference required by 14 CFR
Section 91.175(c)(3) is established. The VDP will
normally be identified by DME on VOR and LOC
procedures and by along track distance to the next
waypoint for RNAV procedures. The VDP is
identified on the profile view of the approach chart by
the symbol: V.
12.6.1 VDPs are intended to provide additional
guidance where they are implemented. No special
14 FEB 08
ENR 1.5−34 AIP
15 MAR 07 United States of America
Nineteenth Edition Federal Aviation Administration
technique is required to fly a procedure with a VDP.
The pilot should not descend below the MDA prior to
reaching the VDP and acquiring the necessary visual
reference.
12.6.2 Pilots not equipped to receive the VDP should
fly the approach procedure as though no VDP had
been provided.
12.7 Visual Portion of the Final Segment. Instrument
procedures designers perform a visual area
obstruction evaluation off the approach end of each
runway authorized for instrument landing, straight−
in, or circling. Restrictions to instrument operations
are imposed if penetrations of the obstruction
clearance surfaces exist. These restrictions vary
based on the severity of the penetrations, and may
include increasing required visibility, denying VDPs
and prohibiting night instrument operations to the
runway.
12.8 Charting of Close in Obstacles on Instrument
Procedure Charts. Obstacles that are close to
the airport may be depicted in either the planview of
the instrument approach chart or the airport sketch.
Obstacles are charted in only one of the areas, based
on space available and distance from the runway.
These obstacles could be in the visual segment of the
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AIP航行情報匯編2(86)