S 865-021
 (20) Remove hydraulic pressure from systems No. 1 and 4 (AMM 29-11-00/201).
 S 495-070
 WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (21)
 Install the ground locks in all landing gear (AMM 09-11-00/201).

 S 735-022

 (22)
 Do a check of the mechanical lock hook on each truck of the wing landing gear (Fig 501):

 (a)  
Move the ground release handles for the main landing gear to the DOORS OPEN position.

 (b)  
Remove the ground lock from the serviced gear.

 (c)  
Move the control lever to the UP position.

 (d)  
Increase the pressure slowly in hydraulic system No. 4 until the mechanical lock hook engages the roller. (AMM 29-11-00/201).

 (e)  
Make sure the mechanical lock hook engages the roller.

 (f)  
Measure the angular travel of the oleo from the gear down position to the position where the truck fully locks up.

 NOTE: You must put the inclinometer on a straight area of the
____ oleo cylinder to accurately measure the oleo travel.
 (g)  
Make sure that the angular travel in the retract direction is not more than 15 degrees.

 (h)  
Move the control lever to the DN position. 1) Make sure the two wing landing gear extend. 2) Make sure the wing landing gear are in the down and locked

 position.

 (i)  
Move the control lever to the OFF position.

 (23)
 Remove the hydraulic pressure from system No. 4 (amm 29-11-00/201).

 (24)
 Install ground locks in all landing gear (AMM 09-11-00/201).

 S 865-023
 S 495-024
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-32-00
 ALL  ú ú 01 Page 509 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 H. Put the Airplane Back to Its Usual Condition.
 S 585-032
 (1)  
Lower the airplane to the ground and remove the jacks (AMM 07-11-01/201).

 S 865-035

 (2)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:

 (a)  
P7 Overhead Panel
 1) 7A03 AURAL WARN L
 2) 7A04 AURAL WARN R

 S 865-037
 (3)  Remove electrical power if it is not necessary (AMM 24-22-00/201).
 TASK 32-32-00-735-113
 3. Main Gear and Main Gear Doors Extension and Retraction - System Test
____________________________________________________________________
 NOTE: It is satisfactory if the "CONFIG GEAR" message shows while you run
____
 the test.

 A. General
_______
 (1)  Monitor the temperature of the hydraulic fluid when you do the test. The fluid temperature must not become more than 100°C (212°F).
 NOTE: If the "SYS FAULT" light on the overhead panel comes on and
____ the "HYD OVHT" message on the EICAS display shows, you must stop the test and allow the hydraulic fluid to cool before you continue.
 B. Special Tools and Equipment
 (1)  G12001 Kit (Rigging Pins) ~................................................................. | Rigging Pin No. | Length (inch) | Diameter (inch) | ................................................................... | WD-1 (LH) | 3.25 | 0.185 to 0.188 | ................................................................... | WD-2 (RH) | 3.25 | 0.185 to 0.188 | 2....................…........................…...................1
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-32-00
 ALL  ú ú 04 Page 510 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 C. References
 (1)  
AMM 07-11-01/201, Jacking Airplane

 (2)  
AMM 09-11-00/201, Towing

 (3)  
AMM 20-41-01/201, Static Grounding
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 4(55)