WARNING:_______ DO NOT GET ACETONE IN YOUR MOUTH OR EYES, OR ON YOUR SKIN. DO
NOT BREATHE THE FUMES FROM THE ACETONE. PUT ON A PROTECTIVE
SPLASH GOGGLE AND GLOVES WHEN YOU USE ACETONE. KEEP ACETONE
AWAY FROM SPARKS, FLAME AND HEAT. ACETONE IS A POISONOUS AND
FLAMMABLE SOLVENT WHICH CAN CAUSE INJURIES TO PERSONS OR DAMAGE
TO EQUIPMENT.
(5)
Fully clean the area with acetone (CP1039).
S 348-063-C00
(6)
From an abradable liner P/N 335-013-305-6, prepare a patch approximately 0.4 inch (10 mm) longer than the full length of the area to be repaired.
S 348-064-C00
(7)
Trim both ends of the patch with a scalpel so that the patch fits correctly with the adjacent edges of the sound liner shroud.
S 348-065-C00
(8)
Use a 80 or 120 grade adhesive cloth to make the surface of the convex surface of the patch rough (CP2239).
S 378-066-C00
(9)
Use one of these two procedures to apply primer and to prepare the adhesive compound, as follows:
NOTE: The primer/adhesive combinations available for this repair
____ are:
-
Primer MB (CP2340) and adhesive compound RTV 147A (CP2297) and RTV 147B (CP2298)
-
Primer SS 4155 (CP22215) and adhesive compound RTV 630, Parts A and B (CP2339)
It is necessary to apply only one primer/adhesive combination for this repair.
(a) To use primer MB (CP2340) and adhesive compound RTV 147A (CP2297) and RTV 147B (CP2298), do the steps that follow: 1) Apply primer MB (CP2340) on the fan case, at the location
of the patch, as follows:
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-33-00
ALL ú ú C01 Page 813 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
CAUTION: MAKE SURE THE AREA IS FULLY CLEAN AND FREE OF
_______ OILY DEPOSITS. DO NOT APPLY TOO MUCH PRIMER. THIS WOULD DECREASE THE ADHERENCE OF THE PATCH TO THE FAN CASE. NEVER TOUCH THE PRIMER ONCE IT IS APPLIED.
a) Use a lint-free cloth or clean paint brush to apply primer MB (CP2340) on the roughened surface of the case.
b) Allow the primer to dry at room temperature for one (1) hour. 2) Prepare the adhesive compound of base RTV 147A (CP2297) and hardener RTV 147B (CP2298) as follows:
WARNING: PUT ON PROTECTIVE GLOVES WHEN YOU MIX OR USE USE
_______ THE BASE AND HARDENER. IF YOU DO NOT OBEY THIS PRECAUTION, INJURY TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
a) Mix, by weight, 10 parts of the hardener RTV 147B (CP2298) and 100 parts of the base RTV 147A (CP2297).
NOTE: The preparation is made at room temperature.
____
b) Slowly mix the base and hardener to prevent air bubbles in the mixture. c) Stir the mixture manually or mechanically until you get a homogeneous compound. d) Make sure the compound contains no visible air bubbles.
NOTE: The compound has a pot-life of approximately
____ two hours at room temperature.
(b) To use primer SS 4155 (CP22215) and adhesive compound RTV 630 Parts A and B (CP2339), do the steps that follow: 1) Apply primer SS 4155 (CP22215) on the fan case, at the
location of the patch, as follows:
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-33-00
ALL ú ú C01 Page 814 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
CAUTION: MAKE SURE THE AREA IS FULLY CLEAN AND FREE OF
_______ OILY DEPOSITS. DO NOT APPLY TOO MUCH PRIMER. THIS WOULD DECREASE THE ADHERENCE OF THE PATCH TO THE FAN CASE. NEVER TOUCH THE PRIMER ONCE IT IS APPLIED.
a) Use a lint-free cloth or clean paint brush to apply the primer SS 4155 (CP2215) on the roughened surface of the case.
b) Allow the primer to dry at room temperature for one (1) hour. 2) Prepare the adhesive compound of RTV 630 Parts A and B (CP2339) as follows:
WARNING: PUT ON PROTECTIVE GLOVES WHEN YOU MIX OR USE THE
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 ENGINE 發動機 2(33)
