CES CES
R (b) Other damage (cracks, scratches, stress, marks, dents,
R bumps,...):
R - If you find other damage, refer to the Structural Repair Manual
R (Ref. SRM 511100,P.Block 001) for damage classification and
R corrective action.
R Subtask 53-11-00-916-073
R B. Application of the Temporary Protection
R CAUTION : DO NOT APPLY TEMPORARY PROTECTION ON THE OXYGEN SYSTEMS._______
R MAKE SURE THAT THE TEMPORARY PROTECTION DOES NOT GET:
R -ON COMPOSITE PARTS, CONTROL CABLES, PULLEYS,TEFLON BEARINGS.
R -ON LUBRICATED SURFACES.
R -IN DRAIN VALVES OR OTHER ORIFICES.
R TEMPORARY PROTECTION ON OR IN THESE PARTS CAN CAUSE DAMAGE.
R (1) Apply masking paper or masking tape BONDING AND ADHESIVE COMPOUNDS
R (Material No. 08-074) on the equipment and fitting adjacent to the
R area.
R (2) Apply a layer of STORAGE PRESERVATION (Material No. 15-005) or
R STORAGE PRESERVATION (Material No. 15-006) to the inspection area.
R (3) Apply a layer of STORAGE PRESERVATION (Material No. 15-008) or
R STORAGE PRESERVATION (Material No. 15-007) to the inspection area.
R (4) Remove the masking tape or the masking paper.
R 5. Close-up________
R Subtask 53-11-00-420-067
R A. Installation of the component
R (1) Install the girt-bar fitting blanking-plates (Ref. TASK 52-11-31-400-
R 005).
R Subtask 53-11-00-410-104
R B. Close Access
R (1) Make sure that the work area is clean and clear of tool(s) and other
R items.
R (2) Close the forward passenger/crew door 831 (841), (Ref. TASK 52-10-00-
R 410-001).
R (3) Remove the access platform(s).
PROTECTIVE SHIELDS - FR1 - REMOVAL/INSTALLATION
_______________________________________________
TASK 53-11-41-000-001 Removal of the Protective Shields - FR1 CAUTION : DO NOT USE THE LOCALIZER ANTENNA AT THE BOTTOM OF THE RADOME AS A
_______ SUPPORT.
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
Power 53-15-11-010-001 Opening of the Radome 110AL 53-11-41-991-001 Fig. 401 53-11-41-991-002 Fig. 402
3. Job Set-up
__________ Subtask 53-11-41-861-050
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001)
EFF : ALL
53-11-41Page 401
Subtask 53-11-41-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
R **ON A/C 051-099,
R 121VU COM NAV/RADAR/2 5SQ2 K14 R **ON A/C ALL
Subtask 53-11-41-010-050
C. Get Access
(1)
Put an access platform in position below the radome in the zone 110.
(2)
Open the radome 110AL (Ref. TASK 53-15-11-010-001). WARNING : DO NOT OPEN THE RADOME IF THE WIND SPEED IS MORE THAN 35
_______
KNOTS.
NOTE : Two persons are necessary to open the radome.
____
4. Procedure
_________
Subtask 53-11-41-020-050
A. Removal of the Protective Shields (Ref. Fig. 401/TASK 53-11-41-991-001, 402/TASK 53-11-41-991-002) 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(87)
