C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-31-41-000-001
25-31-41-000-002
25-31-41-400-001
25-31-41-400-002
25-41-41-000-001
25-41-41-400-001
25-41-42-000-001
25-41-42-400-001
R 52-10-00-010-001 R 52-10-00-410-001 53-12-12-000-001 53-12-12-400-001
SRM 511100 P.Block 001 SRM 512200 P.Block 001
R 53-11-00-991-061
3. Job Set-up
__________
Subtask 53-11-00-010-083
R A. Get Access Removal of the FWD Galley Unit (6475MM)Removal of the FWD Galley Unit (6478MM or 6479MM)Installation of the FWD Galley Unit (6475MM)Installation of the FWD Galley Unit (6478MM or 6479MM)Removal of the Lavatory AInstallation of the Lavatory ARemoval of the Lavatory BInstallation of the Lavatory B Opening of the Passenger/Crew Door Closing of the Passenger/Crew DoorRemoval of the Cabin Floor Panels from FR12 thru FR24Installation of the Cabin Floor Panels from FR12 thru FR24(for corrective action)(for corrective action) Fig. 652
R (1) Put an access platform in position at the zone 831 (841).
R (2) Open the forward passenger/crew door 831 (841), (Ref. TASK 52-10-00-R 010-001). R
R (3) Remove the lavatories, if installed (Ref. TASK 25-41-41-000-001) R (Ref. TASK 25-41-42-000-001).
R (4) Remove the galleys, if installed (Ref. TASK 25-31-41-000-001) R (Ref. TASK 25-31-41-000-002).
R (5) Remove the floor panels from FR12 to FR21 (Ref. TASK 53-12-12-000-001).
EFF : ALL 53-11-00Page B603 Aug 01/03
CES CES
Subtask 53-11-00-110-097
B. Cleaning of the Structure
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
R R R (1) Clean the inspection area with CLEANING AGENTS (Material No. 11-004) and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003), if necessary.
4. Procedure_________
Subtask 53-11-00-220-063
R A. Inspection (Ref. Fig. 652/TASK 53-11-00-991-061)
R R (1) Do a detailed inspection of the structure of the cabin floor between FR12 and FR21.
(2) Make sure that there is no:
R R R (a) Corrosion damage: - If you find corrosion damage, refer to the Structural Repair Manual (Ref. SRM 512200 P.Block 001) for types of corrosion, inspection, removal and corrosion protection.
R R R (b) Other damage (cracks, scratches, stress, marks, dents, bumps,...): - If you find other damage, refer to the Structural Repair Manual (Ref. SRM 511100 P.Block 001) for damage classification and corrective action.
R R Floor Structure FR12 to FR21 Figure 652/TASK 53-11-00-991-061
EFF : ALL 53-11-00 Page B605 Aug 01/03
CES
Subtask 53-11-00-916-060
R B. Application of the Temporary Protection
CAUTION : DO NOT APPLY TEMPORARY PROTECTION ON THE OXYGEN SYSTEMS._______ MAKE SURE THAT THE TEMPORARY PROTECTION DOES NOT GET: -ON COMPOSITE PARTS, CONTROL CABLES, PULLEYS,TEFLON BEARINGS. -ON LUBRICATED SURFACES. -IN DRAIN VALVES OR OTHER ORIFICES. TEMPORARY PROTECTION ON OR IN THESE PARTS CAN CAUSE DAMAGE.
R R R (1) Apply masking paper or masking tape BONDING AND ADHESIVE COMPOUNDS (Material No. 08-074) on the equipment and fitting adjacent to the area.
(2) Apply a layer of STORAGE PRESERVATION (Material No. 15-005) or STORAGE PRESERVATION (Material No. 15-006) to the inspected area.
(3) Apply a layer of STORAGE PRESERVATION (Material No. 15-008) or STORAGE PRESERVATION (Material No. 15-007) to the inspection area.
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(78)
