Aug 01/03
R
CES C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
25-23-42-000-001 Removal of the Ceiling Panels - Forward Utility Area 25-23-42-400-001 Installation of the Ceiling Panels - Forward Utility Area 25-23-45-000-002 Removal of the Door Frame Linings at the Right FWD Passenger/Crew Door 25-23-45-000-005 Removal of the Door Frame Linings at the Left FWD Passenger/Crew Door 25-23-45-400-006 Installation of the Door Frame Linings at the Left FWD Passenger/Crew Door 25-23-45-400-007 Installation of the Door Frame Linings at the Right
FWD Passenger/Crew Door
25-80-00-000-001 Removal of the Insulation Blankets
25-80-00-400-001 Installation of the Insulation Blankets
52-10-00-010-001 Opening of the Passenger/Crew Door
52-10-00-410-001 Closing of the Passenger/Crew Door
SRM 511100 P.Block 001 (for corrective action)
SRM 512200 P.Block 001 (for corrective action)
53-11-00-991-020 Fig. 633
3. Job Set-up
__________
Subtask 53-11-00-010-061-A
A. Get Access
R (1) Put an access platform in position at zone 831 (841).
(2)
Open the forward passenger/crew door 831 (841), and lock it in the open position (Ref. TASK 52-10-00-010-001).
(3)
Remove the lining panels around the frame of the passenger/crew door at FR16 and FR20:
-
For the frame of the left door: 221AW, 221BW, 221CW, 221EW, 221FW, 221RW, 221SW, 221VW, (Ref. TASK 25-23-45-000-005).
-
For the frame of the right door: 222RW, 222SW, 222TW, 222UW, 222VW, (Ref. TASK 25-23-45-000-002).
(4)
Remove the ceiling panels:
-
for the left door:
221BC. (Ref. TASK 25-23-42-000-001)
-
for the right door:
222BC. (Ref. TASK 25-23-42-000-001)
(5)
Remove the insulation blankets around the frame of the passenger/crew door. (Ref. TASK 25-80-00-000-001)
Subtask 53-11-00-110-078
B. Cleaning of the Structure
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1) Clean the inspection area with CLEANING AGENTS (Material No. 11-004) and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003), if necessary.
4. Procedure
_________
Subtask 53-11-00-220-083
A. Inspection
(Ref. Fig. 633/TASK 53-11-00-991-020)
(1) Do a detailed inspection of the internal structure around the forward
passenger/crew door, left and right sides. This inspection is R applicable above the cabin floor level, between FR15 and FR21 and R between STGR8 and STGR23. This inspection does not include the bottom R corners of the door entrance area at FR16 and FR20, between STGR 22 R and 23.
(2) Make sure that there is no:
(a)
corrosion damage:
-If you find corrosion damage, refer to the Structural Repair Manual (Ref. SRM 512200 P.Block 001) for types, inspection, removal and corrosion protection.
(b)
other damage (cracks, scratches, stress, marks, dents,
R R Internal Structure around the Passenger/Crew Doors Figure 633/TASK 53-11-00-991-020
EFF : ALL 53-11-00 Page A625 Aug 01/03
CES
bumps,...): R - If you find other damage, refer to the Structural Repair Manual R (Ref. SRM 511100 P.Block 001) for damage classification and R corrective action.
Subtask 53-11-00-916-050
R B. Application of the Temporary Protection
CAUTION : DO NOT APPLY TEMPORARY PROTECTION ON THE OXYGEN SYSTEMS.
_______ MAKE SURE THAT THE TEMPORARY PROTECTION DOES NOT GET: -ON COMPOSITE PARTS, CONTROL CABLES, PULLEYS,TEFLON BEARINGS. -ON LUBRICATED SURFACES. -IN DRAIN VALVES OR OTHER ORIFICES. TEMPORARY PROTECTION ON OR IN THESE PARTS CAN CAUSE DAMAGE.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(62)
