曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. 
R  OBEY THE MANUFACTURERS INSTRUCTIONS. 
R  PUT ON PROTECTIVE CLOTHING. 
R  DO NOT GET THEM IN YOUR MOUTH. 
R  DO NOT SMOKE. 
R  DO NOT BREATHE THE GAS. 
R  THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. 
R  GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED. 
R  WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THIS/THESE_______ 
R  MATERIAL/S. 
R  USE PROTECTIVE CLOTHING, RUBBER GLOVES, GOGGLES AND A MASK. 
R  (1) Clean the inspection area with CLEANING AGENTS (Material No. 11-004) 
R  and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003), if 
R  necessary. 
R  4. Procedure_________ 
R  Subtask 53-21-00-220-050 
R  A. Inspection 
R  (Ref. Fig. 601/TASK 53-21-00-991-020) 
R  (1) Do a detailed inspection of the internal structure around the forward 
R  emergency exit cutouts between FR35 and FR35.3 : 
R  - for the left side, from STGR23 to STGR7 
R  - for the right side, from STGR23 to STGR10. 

 

R R  Forward Emergency Exit Cutouts - Internal Structure Figure 601/TASK 53-21-00-991-020- 12 (SHEET 1) 
R  EFF :  301-399,  53-21-00 Page 604 May 01/04
 CES 

 

R R  Forward Emergency Exit Cutouts - Internal Structure Figure 601/TASK 53-21-00-991-020- 22 (SHEET 2) 
R  EFF :  301-399,  53-21-00 Page 605 May 01/04
 CES 

 

R (2) Make sure that there is no:

R  (a) Corrosion damage: 
R  - If you find corrosion damage, refer to the Structural Repair 
R  Manual (Ref. SRM 512200 P.Block 001) for types of corrosion, 
R  inspection, removal and corrosion protection. 
R  (b) Other damage (cracks, scratches, stress, marks, dents, 
R  bumps,...): 
R  - If you find other damage, refer to the Structural Repair Manual 
R  (Ref. SRM 511100 P.Block 001) for damage classification and 
R  corrective action. 
R  Subtask 53-21-00-916-050 
R  B. Application of the Temporary Protection 
R  (Ref. Fig. 601/TASK 53-21-00-991-020) 
R  CAUTION : DO NOT APPLY TEMPORARY PROTECTION ON THE OXYGEN SYSTEMS._______ 
R  MAKE SURE THAT THE TEMPORARY PROTECTION DOES NOT GET: 
R  -ON COMPOSITE PARTS, CONTROL CABLES, PULLEYS,TEFLON BEARINGS. 
R  -ON LUBRICATED SURFACES. 
R  -IN DRAIN VALVES OR OTHER ORIFICES. 
R  TEMPORARY PROTECTION ON OR IN THESE PARTS CAN CAUSE DAMAGE. 
R  (1) Put masking paper or masking tape BONDING AND ADHESIVE COMPOUNDS 
R  (Material No. 08-074) on the equipment and fittings adjacent to the 
R  area. 
R  (2) Apply a layer of STORAGE PRESERVATION (Material No. 15-005) or 
R  STORAGE PRESERVATION (Material No. 15-006) on the inspection area. 
R  (3) Remove the masking paper or masking tape. 
R  5. Close-up________ 
R  Subtask 53-21-00-410-058 
R  A. Close Access 
R  (1) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  (2) Install the insulation blankets (Ref. TASK 25-80-00-400-001). 
R  (3) Install the overhead stowage compartments, if removed. 

 CES

R  (4) Install the ceiling panels (Ref. TASK 25-23-41-400-001). 
R  (5) Install the cove light panels 231CX, 231FX, 231RX, 232CX, 232FX, 
R  232RX (Ref. TASK 25-23-48-400-001). 
R  (6) Install the sidewall panels 231AX, 232AX, 231PX, 232PX, 231BX, 232BX, 
R  231QX, 232QX (Ref. TASK 25-23-43-400-001). 
R  (7) Install the door frame linings (Ref. TASK 25-23-47-400-004) 
R  (Ref. TASK 25-23-47-400-009). 
R  (8) Close the forward emergency exit door 833 (843) (Ref. TASK 52-22-00-
R  410-001). 
R  (9) Remove the access platform(s). 

R TASK 53-21-00-200-019

R Detailed Inspection of Door Stop Fittings on FR 35.1 and FR 35.2A, LH/RH R 1. Reason for the Job
__________________ R Refer to the MPD TASK: 532114-01 R 2. Job Set-up Information
______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------R REFERENCE QTY DESIGNATION
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(133)