1EFF : ALL 1 32-00-00Page 215 1 1 Aug 01/05 1 1 1CES 1 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------**ON A/C 051-051,
2001VU WASTE WIP-DRAINMAST-AFT 11DU D04 **ON A/C ALL
Subtask 32-00-00-869-053
B. Reconfigure the Avionics Compartment Ventilation System CAUTION : DO NOT PUT THE AIRCRAFT BACK TO THE GROUND CONFIGURATION WHILE
_______ THE AVIONICS-COMPARTMENT VENTILATION SYSTEM IS RECONFIGURED. IF YOU DO, THERE IS A RISK THAT THE EQUIPMENT IN THE AVIONICS COMPARTMENT WILL BECOME TOO HOT.
(1) Do a reconfiguration of the avionics compartment ventilation system (Ref. TASK 21-26-00-860-001).
NOTE : The flight configuration precautions are complete and
____ electrical power can be put back without damage to the anti-ice heat elements.
(2) To put power back to the aircraft, do one or the two of the steps that follow:
(a) On the ELEC panel 35VU, set the EXT PWR pushbutton switch to the ON position.
(b) On the panel 2000VU, set the MAINT BUS switch to the ON position. Subtask 32-00-00-869-054
C. Put the Aircraft Back to the Ground Configuration
(1) When you have done the maintenance tasks necessary, do the ground configuration after flight configuration with electrical power procedure (Ref. TASK 32-00-00-860-002).
1EFF : ALL 1 32-00-00Page 216 1 1 Aug 01/05R 1 1 1CES 1
TASK 32-00-00-860-002 Ground Configuration after Flight Configuration with Electrical Power WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
To put the aircraft back to the correct (ground) condition after it was in a flight configuration with electrical power. NOTE : Do this task only if you have done the Flight Configuration
____
Precautions with Electrical Power procedure (Ref. TASK
32-00-00-860-00100).
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
21-26-00-860-001 Configuration of the Avionics Compartment Ventilation System
3. Job Set-up
__________ Subtask 32-00-00-869-055
A. Aircraft Maintenance Configuration
(1)
On the ELEC panel 35VU, set the EXT PWR pushbutton switch to the OFF position.
(2)
On the panel 2000VU, set the MAINT BUS switch to the OFF position.
(3)
Put the avionics compartment ventilation system back to the normal ground configuration (Ref. TASK 21-26-00-860-001).
1EFF : ALL 1 32-00-00Page 217 1 1 May 01/05R 1 1 1CES 1
4. Procedure
_________
CAUTION : YOU MUST CLOSE THE CIRCUIT BREAKERS OPENED FOR AIRCRAFT FLIGHT
_______
CONFIGURATION WHEN THE MAINTENANCE WORK IS COMPLETED.
DAMAGE TO THE AIRCRAFT CAN OCCUR IF THEY STAY OPEN.
Subtask 32-00-00-865-052
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1DA1, 1DA2, 2DA1, 2DA2, 2DA3, 3DA1, 3DA2, 3DA3, 4DA1, 4DA2, 4DA3, 5DA1,
R 5DA2, 5DA3, 5DG1, 5DG2, 1DG1, 1DG2, 4DG1, 4DG2, 1DU, 11DU, 2KS1, 2KS2, 4KS1, 4KS2, 1JH, 2JH1, 2JH2, 3JH1, 3JH2, 1RE1, 1RE2, 1SA1, 1SA2, 4SG, 5SH1, 5SH2, 7TU, 2WW, 3WW.
Subtask 32-00-00-860-060
B. Aircraft Maintenance Configuration
(1) To put power back to the aircraft, do one or the two of the steps that follow:
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架1(83)
