-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
32-43-00-870-002 32-69-00-740-001 57-26-13-000-001 Bleeding of the High Pressure Alternate Braking SystemBITE Check Landing Gear Control Interface Unit (LGCIU) using MCDU to Ensure that Continuous BITE is OperativeRemoval of the Bearing Assembly of the Forward Pintle Pin
57-26-13-400-001 Installation of the Bearing Assembly of the Forward Pintle Pin
57-51-00-200-001 Detailed Visual Inspection of Outer Wing Main Landing Gear Rear Pintle Pin
CMM 32-11-33 CMM 32-12-22 CMM 32-12-25 SIL 12-008 32-11-11-991-006 (for corrective action)(for corrective action)(for corrective action)(for corrective action)Fig. 401
**ON A/C 001-049, 051-061, 101-105, 201-203,
32-11-11-991-027 Fig. 402
**ON A/C 301-399,
32-11-11-991-027-B Fig. 402A
R **ON A/C 001-049, 062-099, 101-149, 151-199, 201-299, 401-499, Post SB 32-1213 For A/C 001-049,101-105,201-203,
32-11-11-991-027-A Fig. 402B
**ON A/C ALL
32-11-11-991-023 Fig. 403
32-11-11-991-013-A Fig. 404
32-11-11-991-014 Fig. 405
32-11-11-991-008 Fig. 406
1EFF : ALL 1 32-11-11Page 438 1 1 Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
32-11-11-991-009 Fig. 407
**ON A/C 301-399,
32-11-11-991-009-A Fig. 407A
**ON A/C ALL
3. Job Set-up
__________
Subtask 32-11-11-941-053
A. Safety Precautions
(1)
Make sure that the safety barriers are in position.
(2)
Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).
(3)
On the panel 400VU:
-
make sure that the landing-gear control-lever 6GA is in the DOWN position
-
make sure that the warning notice is in position to tell persons not to operate the landing gear
-
make sure that the warning notice is in position to tell persons not to operate the landing-gear doors.
(4)
Make sure that the warning notices are in the cockpit to tell persons not to operate the brakes.
(5)
Make sure that the warning notices are in the cockpit to tell persons not to operate the flap controls.
(6)
Make sure that the warning notices are on the ground service connections to tell persons not to operate the Green and the Yellow Hydraulic systems.
1EFF : ALL 1 32-11-11Page 439 1 1 Aug 01/05 1 1 1CES 1 **ON A/C 001-049, 051-061, 101-103, 201-203,
Subtask 32-11-11-860-057
B. Aircraft Maintenance Configuration
(1)
Make sure that the Green and the Yellow Hydraulic systems are depressurized (Ref. TASK 29-00-00-864-001).
(2)
Make sure that the applicable hydraulic reservoirs are depressurized (Ref. TASK 29-14-00-614-001).
(3)
Make sure that the flaps are fully extended (Ref. TASK 27-50-00-866-008).
(4)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
(5)
Make sure that the two adjustable access platforms are in position adjacent to the applicable MLG leg assembly (one at the front and one at the rear).
(6)
Make sure that the isolation coupling of the PTU is disconnected (Ref. TASK 29-23-00-860-001).
(7)
Make sure that the applicable MLG door is open (Ref. TASK 32-12-00-010-001).
(8)
Make sure that the GROUND LOCK SLEEVE is installed on the applicable MLG door actuator.
(9)
Make sure that the secondary hinged-fairing assembly is removed (Ref. TASK 32-12-13-000-001).
(10)
Make sure that the applicable access panel is open:
FOR 2501GM
panel 574AB
FOR 2502GM
panel 674AB.
(11)
If the LGCIU circuit breakers were not opened in the removal task, make sure that the electrical circuits are de-energized (Ref. TASK 24-41-00-862-002).
R 1EFF : 001-049, 051-061, 101-103, 201-203, 1 32-11-11Page 440 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 062-099, 104-149, 151-199, 204-299, 301-399, 401-499,
Subtask 32-11-11-860-057-A 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架1(126)
