(2)
Install the cabin wall-mounted emergency-exit-marker 90WL7 (Ref. TASK 33-51-13-400-001).
(3)
Install the cabin emergency light 33WL (Ref. TASK 33-51-11-400-001).
(4)
Install the emergency exit sign 45WL (Ref. TASK 33-51-16-400-001).
(5)
Install the handset cradle 330RH9 (Ref. TASK 23-73-44-400-001).
(6)
Install the AFT attendant panel 126RH (Ref. TASK 23-73-13-400-001).
(7)
Install the attendant indication panel 320RH9 (Ref. TASK 23-73-22-400-001).
EFF : ALL
25-23-45Page 435
Subtask 25-23-45-210-070
B. Preparation for Installation
(1)
Clean the component interface and/or the adjacent area.
(2)
Do an inspection of the component interface and/or the adjacent area.
(3)
Make sure that all placards of the retained/new components are in the correct position and in good condition.
(4)
If necessary install new placards, refer to (Ref. TASK 11-00-00-400-002) and (Ref. AMM 11-32-25 P.Block 001)
Subtask 25-23-45-865-055
C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 5ME
Subtask 25-23-45-862-053
D. De-energize the ground service network
(Ref. TASK 24-42-00-862-001)
EFF : ALL
25-23-45Page 436
May 01/03
R
CES TASK 25-23-45-000-004
Removal of the Door Frame Linings at the Right AFT Passenger/Crew Door
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific 1 CAP - BLANKING, PLASTIC No specific 1 PLUG - BLANKING, PLASTIC No specific 1 SCREWDRIVER - SMALL
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
Power 33-51-11-000-001 Removal of the Cabin Emergency Lights 33-51-13-000-001 Removal of the Cabin Wall-Mounted
Emergency-Exit-Markers 33-51-16-000-001 Removal of the Emergency Exit Sign 52-10-00-010-001 Opening of the Passenger/Crew Door 25-23-45-991-005-A Fig. 404
3. Job Set-up
__________
Subtask 25-23-45-861-054
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001)
EFF : ALL
25-23-45Page 437
May 01/03
R
CES Subtask 25-23-45-010-052
B. Get Access
(1)
Open the AFT passenger/crew door, Zone 842 (Ref. TASK 52-10-00-010-001).
(2)
Remove the emergency exit sign 44WL (Ref. TASK 33-51-16-000-001).
(3)
Remove the cabin emergency light 32WL (Ref. TASK 33-51-11-000-001).
(4)
Remove the cabin wall-mounted emergency-exit marker 90WL8 (Ref. TASK 33-51-13-000-001).
4. Procedure
_________ Subtask 25-23-45-020-054-A
A. Removal of the door frame linings 262VW, 262UW, 262TW, 262WW.
(Ref. Fig. 404/TASK 25-23-45-991-005-A)
(1) Remove the lining 262VW: CAUTION : MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU
_______ DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.
(a)
Disconnect the electrical connector (19) from the electrical harness.
(b)
Put CAP - BLANKING, PLASTIC on the disconnected electrical connectors.
(c)
Loosen the clamp (6) and disconnect the hose (5).
(d)
Put PLUG - BLANKING, PLASTIC on the disconnected line ends.
(e)
Hold the lining 262VW in position.
(f)
Remove the caps (3), the screws (1), (4) and (8), the washers (2) and (7) and remove the lining 262VW.
(2) Remove the lining 262UW:
(a) Remove the screws (1) and the washers (2) and the lining 262UW.
EFF : ALL
25-23-45Page 438
May 01/03
R
CES
INTENTIONALLY BLANK
Door Frame Linings at the AFT Passenger/Crew Door, right Side. Figure 404/TASK 25-23-45-991-005-A12 (SHEET 1)
EFF : ALL
25-23-45Page 440
May 01/03 R CES
Door Frame Linings at the AFT Passenger/Crew Door, right Side. Figure 404/TASK 25-23-45-991-005-A22 (SHEET 2)
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備2(28)
