曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

button.
Revision 5: 08-15-07
24 of 24 P/N 13772-108
Section 9 Cirrus Design
Supplements SR22
DH (Decision Height) – The DH button allows entry and arming of
altitude alerting at a set decision height. To set a DH, first enter the
data (DTA) entry (ENT) mode, press the DH button, and rotate the
selector knob to input the desired decision height to the nearest 100
feet above the specified decision height. For example, for a DH of
1160 feet set 1.2 (1200 feet). After setting the desired decision height,
press the DTA button again to accept the entered DH. The display will
show the selected DH for approximately 5 seconds and then revert to
Alt mode until the selected DH is reached during descent. The DH
annunciator will remain illuminated indicating a decision height is set.
As the airplane approaches within approximately 50 feet of the
decision height, the alert will sound and the DH light will flash. As the
airplane passes through approximately 50 feet beyond the decision
height, the alert will sound and the light will flash again. Pressing the
DH button again will disable the DH function causing the DH
annunciation to go out. Repeated activation of the DH button
alternately activates and deactivates the DH mode.
VS (Vertical Speed) – At initial start up, after self-test, pressing the
Altitude Selector / Alerter VS button enables vertical speed selector
mode. The initial vertical speed will be set at + 2 indicating a climb at
200 feet per minute. Rotating the selector input knob will change the
selected vertical speed in 100 FPM increments. Rotate CW to
increase vertical speed or CCW to Decrease vertical speed. The
maximum vertical speed is ± 1600 FPM (± 16). Zero vertical speed is
not selectable.
The vertical speed display is the only Altitude Selector / Alerter
function available in the ‘operate’ mode. Therefore, vertical speed
changes can be commanded by rotating the selector input knob.
Vertical speeds can also be entered in the data (DTA) entry (ENT)
mode by pressing the VS button and using the selector input knob to
enter a new vertical speed. The DTA button must be pressed again to
accept the new vertical speed and enter the ‘operate’ mode.
The Altitude Selector / Alerter VS mode can be disabled by pressing
the Altitude Selector / Alerter MAN button.
MAN (Manual) – Vertical Speed selection can be completely
decoupled from the autopilot system by depressing the Altitude
Selector / Alerter MAN button.
Revision 5: 08-15-07
P/N 13772-121 1 of 12
Cirrus Design Section 9
SR22 Supplements
Pilot’s Operating Handbook and
FAA Approved Airplane Flight Manual
Supplement
for
Honeywell KGP 560 Terrain
Awareness/Warning System
When the Honeywell KGP 560 Terrain Awareness and Warning
System is installed in the Cirrus Design SR22, this Supplement is
applicable and must be inserted in the Supplements Section (Section
9) of the Cirrus Design SR22 Pilot’s Operating Handbook. This
document must be carried in the airplane at all times. Information in
this supplement adds to, supersedes, or deletes information in the
basic SR22 Pilot’s Operating Handbook.
• Note •
This POH Supplement Revision dated Revision 1: 12-15-07
supersedes and replaces the original release of this supplement dated
Original: 07-03-04.
Revision 1: 12-15-07
2 of 12 P/N 13772-121
Section 9 Cirrus Design
Supplements SR22
Section 1 - General
The airplane is equipped with an Honeywell KGP 560 Terrain
Awareness and Warning System that performs the functions of a
Class C Terrain Awareness and Warning System (TAWS) in
accordance with TSO C151b.
Incorporating much of the technology found in TAWS for air transport
aircraft, the KPG 560 supports:
• Alerting for premature descent.
• Alerting for excessive rate of climb/descent.
• Altitude callout (500 ft) and alerting within 5 nm of 2000 ft public
runways.
• Look-ahead algorithms and integrated terrain/obstacle
database.
The system consists of the 560 GA-EGPWS Processor mounted on
the underside of the pilot-side kickplate, a Terrain/Obstacle Database
integral to the processor, the Configuration Module integral to the
system’s wire harness, and the TAWS annunciator panel mounted on
the lower LH portion of the instrument panel.
The KGP 560 receives data from the GPS sensor, Transponder,
Primary Flight Display, and the Multifunction Display (MFD). Aural
alerts are communicated to the pilot via the GMA 340 Audio Panel. To
enhance the situational awareness to the pilot, color-coded terrain
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Cirrus Design SR20西銳20飛行員操作手冊和飛機飛行手冊附錄(69)